| History log of /src/sys/dev/ic/bwfmvar.h |
| Revision | | Date | Author | Comments |
| 1.14 |
| 03-Dec-2022 |
mlelstv | Fix bug in protocol parser that often caused fatal 'checksum error'.
Defer power save setting to interface start.
More verbose on errors.
Allow build without FDT.
|
| 1.13 |
| 14-Mar-2022 |
mlelstv | Add OpenBSD to code to optionally load CLM (Country Locale Matrix) files.
|
| 1.12 |
| 22-Jul-2020 |
riastradh | bwfm: Switch from pcq to pool_cache.
pcq_get is required to be serialized, but it's far from clear that it
is serialized here.
|
| 1.11 |
| 22-Jul-2020 |
riastradh | Add include guards and appropriate includes to bwfmreg.h, bwfmvar.h.
No functional change intended.
|
| 1.10 |
| 30-May-2020 |
jdolecek | discussed with thorpej@, and it seems it's better to allocate the bss
alignment buffer statically (as part of softc) just to be sure to not
affect performance
|
| 1.9 |
| 30-May-2020 |
jdolecek | constify, and make static where possible
|
| 1.8 |
| 25-Mar-2020 |
thorpej | Add a file type entry for CLM files.
|
| 1.7 |
| 25-Mar-2020 |
thorpej | - Refactor the firmware loading code into a set of common routines in the
core driver that understand how to find model-specific files before the
generic files. This greatly simplifies the firmware loading procedure
in each of the bus front ends. Adding additional firmware file types
(such as CLM files) much simpler.
- Make firmware image selection table-driven rather than a set of switch()
and if() statements.
- Add several additional firmware image entries.
|
| 1.6 |
| 22-Mar-2020 |
thorpej | Add a few more chip ID.
|
| 1.5 |
| 28-Oct-2019 |
mlelstv | More code from OpenBSD
no need to splnet() when enqueing packets
explicit structure padding
make internal functions static
also prepare for GPIO interrupts.
|
| 1.4 |
| 01-Sep-2019 |
mlelstv | From OpenBSD:
- move event handling to workqueue
- check for save/restore capability
Tag work queue as MPsafe and increase length.
Juse use bpf_mtap(), the 802.11 encapsulation is handled by firmware.
|
| 1.3 |
| 01-Sep-2018 |
riastradh | branches: 1.3.2; 1.3.6;
bwfm has only one tx descriptor; limit mbuf chains to one segment.
PR kern/53287
Can't use m_defrag because it always yields two segments.
Discussion on tech-net:
https://mail-index.netbsd.org/tech-net/2018/09/01/msg007031.html
Diagnosed and tested by maya.
|
| 1.2 |
| 11-May-2018 |
maya | branches: 1.2.2;
sync with openbsd bwfm to some extent.
add a txcheck
set chip active/passive for more kinds of chips
add wrapper around setting active/passive
detect chip RAM
make bwfm_rx take an mbuf
|
| 1.1 |
| 19-Oct-2017 |
jmcneill | branches: 1.1.2; 1.1.4;
Add driver for Broadcom 802.11a/b/g/n/ac USB wireless devices, based on
the OpenBSD bwfm(4) driver.
|
| 1.1.4.2 |
| 06-Sep-2018 |
pgoyette | Sync with HEAD
Resolve a couple of conflicts (result of the uimin/uimax changes)
|
| 1.1.4.1 |
| 21-May-2018 |
pgoyette | Sync with HEAD
|
| 1.1.2.2 |
| 03-Dec-2017 |
jdolecek | update from HEAD
|
| 1.1.2.1 |
| 19-Oct-2017 |
jdolecek | file bwfmvar.h was added on branch tls-maxphys on 2017-12-03 11:37:03 +0000
|
| 1.2.2.3 |
| 13-Apr-2020 |
martin | Mostly merge changes from HEAD upto 20200411
|
| 1.2.2.2 |
| 08-Apr-2020 |
martin | Merge changes from current as of 20200406
|
| 1.2.2.1 |
| 10-Jun-2019 |
christos | Sync with HEAD
|
| 1.3.6.2 |
| 17-Aug-2020 |
martin | Pull up following revision(s) (requested by mrg in ticket #1052):
sys/dev/ic/bwfm.c: revision 1.28
sys/dev/ic/bwfm.c: revision 1.29
sys/dev/sdmmc/if_bwfm_sdio.c: revision 1.22
sys/dev/ic/bwfmreg.h: revision 1.7
sys/dev/ic/bwfmvar.h: revision 1.11
sys/dev/ic/bwfmvar.h: revision 1.12
(all via patch)
Add include guards and appropriate includes to bwfmreg.h, bwfmvar.h.
No functional change intended.
Need <sys/kmem.h> for kmem_*.
Currently accidentally side-loaded by <sys/pcq.h>.
bwfm: Switch from pcq to pool_cache.
pcq_get is required to be serialized, but it's far from clear that it
is serialized here.
|
| 1.3.6.1 |
| 25-Feb-2020 |
martin | Pull up following revision(s) (requested by mrg in ticket #717):
sys/dev/fdt/dwcmmc_fdt.c 1.11
sys/dev/ic/bwfm.c 1.15-1.18
sys/dev/ic/bwfmreg.h 1.4-1.6
sys/dev/ic/bwfmvar.h 1.4,1.5
sys/dev/ic/dwc_mmc.c 1.21,1.22
sys/dev/ic/dwc_mmc_reg.h 1.8,1.9,1.12,1.13
sys/dev/pcmcia/pcmciareg.h 1.11
sys/dev/sdmmc/if_bwfm_sdio.c 1.4,1.6-1.12
sys/dev/sdmmc/if_bwfm_sdio.h 1.1,1.2
sys/dev/sdmmc/sdhc.c 1.105,1.106
sys/dev/sdmmc/sdmmc.c 1.37,1.39
sys/dev/sdmmc/sdmmc_cis.c 1.6,1.8
sys/dev/sdmmc/sdmmc_io.c 1.15-1.19
sys/dev/sdmmc/sdmmc_ioreg.h 1.4,1.5
sys/dev/sdmmc/sdmmc_mem.c 1.69-1.71
sys/dev/sdmmc/sdmmcdevs 1.5-1.8
sys/dev/sdmmc/sdmmcvar.h 1.31,1.33,1.34
sys/net/if_media.h 1.66
Add Broadcom devices
-
Fix typo
-
add PCMCIA_CISTPL_SDIO definition.
-
From OpenBSD:
- move event handling to workqueue
- check for save/restore capability
-
Tag work queue as MPsafe and increase length.
-
Juse use bpf_mtap(), the 802.11 encapsulation is handled by firmware.
-
From OpenBSD:
- support block length per function
- add functions to read/write regions
-
Decode (but not use) SDIO tuple in CIS.
-
Fix locking.
-
Add more SDIO defines (partially from version 3.0).
-
From OpenBSD:
- All the missing pieces (firmware load, chip setup, protocol handling)
TX queue and interrupt handling via sdmmc_task.
-
Fix locking.
-
Fix packet parsing.
-
Add parser for original firmware config files.
-
tagging work queue as MPSAFE was premature. Revert.
-
SD_IO_RW_EXTENDED is a data transfer command, so set ADTC flag instead of AC
Use correct function to verify if a task has been queued. Avoids race
that can corrupt the task queue.
-
More register definitions.
-
Add IFM_IEEE80211_VHT subtype, IFM_IEEE80211_11AC operating mode, and missing descriptions
-
If firmware is connected in HT or VHT mode, report it to SIOCGIFMEDIA
-
white space police.
Skip setting power when the voltage doesn't change.
Also increase some timeouts.
-
Add and use sdmmc_pause to avoid long-term busy waits.
-
Add sdio abort function.
-
Additional error messages.
-
Print parameters for SDIO devices.
-
Minor cosmetics.
-
Simplyfy sdmmc_io_set_blocklen function signature by dropping the
extra softc pointer. Aligns with OpenBSD.
-
Missing commit for sdio abort function.
-
More code from OpenBSD
-
no need to splnet() when enqueing packets
-
explicit structure padding
-
make internal functions static
-
also prepare for GPIO interrupts.
-
Avoid warnings for tautological shifts as sole conditional.
-
Follow the Linux driver an use the FDT "compatible" property to build a
filename for the nvram config file, fall back to the standard filename.
E.g.
[Caching 123 nodes and 1093 properties]
compatible 73696e6f 766f6970 2c627069 2d6d322d "sinovoip,bpi-m2-
0010: 7a65726f 00...... ........ ........ zero"
0015: 616c6c77 696e6e65 722c7375 6e38692d "allwinner,sun8i-
0025: 68322d70 6c757300 ........ ........ h2-plus"
interrupt-parent 00000001 ........ ........ ........ ....
model 42616e61 6e612050 69204250 492d4d32 "Banana Pi BPI-M2
0010: 2d5a6572 6f00.... ........ ........ -Zero"
name 00...... ........ ........ ........ ""
serial-number 30326330 30303432 65636431 36376566 02c00042ecd167ef
0010: 00...... ........ ........ ........ .
-rw-r--r-- 1 root wheel 875 Nov 2 12:06 brcmfmac43430-sdio.AP6212.txt
lrwxr-xr-x 1 root wheel 29 Dec 30 16:19 brcmfmac43430-sdio.sinovoip,bpi-m2-zero.txt -> brcmfmac43430-sdio.AP6212.txt
-rw-r--r-- 1 root wheel 874 Jun 30 2019 brcmfmac43430-sdio.raspberrypi,3-model-b.txt
-rw-r--r-- 1 root wheel 1864 Jun 30 2019 brcmfmac43455-sdio.raspberrypi,3-model-b-plus.txt
lrwxr-xr-x 1 root wheel 29 Dec 30 11:24 brcmfmac43455-sdio.raspberrypi,4-model-b-plus.txt -> brcmfmac43455-sdio.raspberrypi,3-model-b-plus.txt
-
Add product ID for Broadcom BCM43455
-
Use correct firmware for BCM43456
-
size check was backwards.
-
Be less noisy for some commands.
-
Fix DWC_MMC_INT_SDIO_INT bit
-
dwc_mmc fixes:
- Rockchip uses a different SDIO int bit, so take this into consideration
- Avoid unnecessary resets and always wait for resets to complete
- kpause instead of delay while holding spinlock
- Do not attempt autostop for SD_IO_RW_EXTENDED commands
- Allow for sub-blklen byte counts for single block transfers
-
More SDIO stability and performance fixes
|
| 1.3.2.2 |
| 31-Oct-2018 |
martin | Backport of bfwm code, requested by maya in ticket #1072:
sys/dev/ic/bwfm.c 1.14
sys/dev/ic/bwfmreg.h 1.3
sys/dev/ic/bwfmvar.h 1.3
sys/dev/pci/if_bwfm_pci.c 1.4
sys/dev/pci/if_bwfm_pci.h 1.8
sys/dev/usb/if_bwfm_usb.c 1.8
via patch.
|
| 1.3.2.1 |
| 01-Sep-2018 |
martin | file bwfmvar.h was added on branch netbsd-8 on 2018-10-31 09:23:00 +0000
|
