Cross Reference: /src/sys/dev/pci/if

Lines Matching refs:BNX_INFO
665 	DBPRINT(sc, BNX_INFO, "bnx_shmem_base = 0x%08X\n", sc->bnx_shmem_base);
691 		DBPRINT(sc, BNX_INFO, "Management F/W Enabled.\n");
938 	DBRUN(BNX_INFO, bnx_dump_driver_state(sc));
1281 			DBPRINT(sc, BNX_INFO, "Enabling 10Mb interface.\n");
1287 		DBPRINT(sc, BNX_INFO, "Enabling MII interface.\n");
1291 		DBPRINT(sc, BNX_INFO, "Enabling 2.5G MAC mode.\n");
1296 		DBPRINT(sc, BNX_INFO, "Enabling GMII interface.\n");
1308 		DBPRINT(sc, BNX_INFO, "Setting Half-Duplex interface.\n");
1311 		DBPRINT(sc, BNX_INFO, "Setting Full-Duplex interface.\n");
1319 		DBPRINT(sc, BNX_INFO, "Enabling RX mode flow control.\n");
1322 		DBPRINT(sc, BNX_INFO, "Disabling RX mode flow control.\n");
1327 		DBPRINT(sc, BNX_INFO, "Enabling TX mode flow control.\n");
1330 		DBPRINT(sc, BNX_INFO, "Disabling TX mode flow control.\n");
2480 	DBPRINT(sc, BNX_INFO, "status_block_paddr = 0x%08X\n",
2571 	DBPRINT(sc, BNX_INFO, "stats_block_paddr = 0x%08X\n",
2620 		DBPRINT(sc, BNX_INFO, "tx_bd_chain_paddr[%d] = 0x%08X\n",
2678 		DBPRINT(sc, BNX_INFO, "rx_bd_chain_paddr[%d] = 0x%08X\n",
3447 	DBPRINT(sc, BNX_INFO, "Permanent Ethernet address = "
3463 	DBPRINT(sc, BNX_INFO, "Setting Ethernet address = "
4508 			DBPRINT(sc, BNX_INFO, "Link is now UP.\n");
4512 			DBPRINT(sc, BNX_INFO, "Link is now DOWN.\n");
5025 	DBPRINT(sc, BNX_INFO, "%s(): setting MRU = %d\n", __func__, ether_mtu);
5037 	DBPRINT(sc, BNX_INFO, "%s(): mclbytes = %d, mbuf_alloc_size = %d, "
5600 		DBPRINT(sc, BNX_INFO, "Enabling promiscuous mode.\n");
5608 		DBPRINT(sc, BNX_INFO, "Enabling all multicast mode.\n");
5618 		DBPRINT(sc, BNX_INFO, "Enabling selective multicast mode.\n");
OpenGrok
