| /src/tests/net/if_wg/ |
| t_basic.sh | 357 local port2=51821
375 setup_wg_common wg1 inet $ip_wg_local2 24 $port2 "$key_priv_local"
377 add_peer wg1 peer0 $key_pub_peer2 $ip_peer2:$port2 $ip_wg_peer2/32
388 setup_wg_common wg0 inet $ip_wg_peer2 24 $port2 "$key_priv_peer2"
389 add_peer wg0 peer0 $key_pub_local $ip_local2:$port2 $ip_wg_local2/32
|
| /src/sys/external/gpl2/dts/dist/arch/arm/boot/dts/ |
| omap3-igep0030-common.dtsi | 89 port2-mode = "ehci-phy";
|
| sun7i-a20-lamobo-r1.dts | 155 port2: port@2 { label in label:switch
|
| omap3-evm-common.dtsi | 169 port2-mode = "ehci-phy";
|
| imx51-zii-scu3-esb.dts | 239 label = "port2";
|
| logicpd-som-lv.dtsi | 147 port2-mode = "ehci-phy";
|
| omap3-beagle-xm.dts | 358 port2-mode = "ehci-phy";
|
| omap3-beagle.dts | 300 port2-mode = "ehci-phy";
|
| omap3-cm-t3x.dtsi | 206 port2-mode = "ehci-phy";
|
| omap3-overo-base.dtsi | 202 port2-mode = "ehci-phy";
|
| omap3-tao3530.dtsi | 248 port2-mode = "ehci-phy";
|
| motorola-mapphone-common.dtsi | 667 port2-mode = "ehci-tll";
|
| omap3-pandora-common.dtsi | 578 port2-mode = "ehci-phy";
|
| omap5-board-common.dtsi | 685 port2-mode = "ehci-hsic";
|
| omap5-cm-t54.dts | 638 port2-mode = "ehci-hsic";
|
| r7s72100.dtsi | 519 port2: gpio-2 { label in label:pinctrl
|
| mt7623.dtsi | 728 <0 0x1a144000 0 0x1000>; /* Port2 registers */
729 reg-names = "subsys", "port0", "port1", "port2";
|
| omap3-gta04.dtsi | 620 port2-mode = "ehci-phy";
|
| /src/sys/external/gpl2/dts/dist/arch/mips/boot/dts/mscc/ |
| ocelot_pcb120.dts | 83 &port2 {
|
| ocelot.dtsi | 141 "port2", "port3", "port4", "port5", "port6",
159 port2: port@2 { label
|
| /src/sys/dev/ieee1394/ |
| firewire.h | 316 port2:2, member in struct:fw_self_id::__anon8bc821541008
358 port2:2, member in struct:fw_self_id::__anon8bc821541308
|
| firewire.c | 1006 if (self_id->p0.port2 >= 0x2)
1602 s->p0.port2, s->p0.initiated_reset, s->p0.more_packets);
|
| /src/sys/external/gpl2/dts/dist/arch/arm64/boot/dts/microchip/ |
| sparx5_pcb135_board.dtsi | 388 port2: port@2 { label
|
| /src/usr.sbin/fwctl/ |
| fwcontrol.c | 521 printf("id link gap_cnt speed delay cIRM power port0 port1 port2"
539 port_status[sid.p0.port2],
|
| /src/sys/netipsec/ |
| key.c | 4796 key_portcomp(in_port_t port1, in_port_t port2, int howport)
4802 if (port1 == 0 || port2 == 0)
4806 if (port1 != port2) {
4808 "port fail %d != %d\n", ntohs(port1), ntohs(port2));
|
