hardware revision 1.1 
1NetBSD/atari 1.1 runs on a TT030 and a Falcon. Currently an FPU is
2required, although this might change in the (near) future. The
3minimum amount of RAM required is 4Mb.
4
5Here is a table of recommended HD partition sizes for a full install:
6	partition:	advise,	with X,	needed,	with X
7	root (/)	15M	15M	10M	10M
8	user (/usr)	65M	100M	45M 	80M
9	swap		----- 2M for every M ram -----
10	local (/local)	up to you
11
12As you may note the recommended size of /usr is 20M greater than
13needed. This is to leave room for a kernel source and compile tree
14as you will probably want to compile your own kernel. (GENERIC is
15large and bulky to accommodate all people, BOOT is small and might
16not have all the features you want).
17
18Supported devices include:
19	- The buildin SCSI host adapter
20		- Should support most SCSI-drives. The drives that are
21		  currently tested are:
22			MAXTOR 7245S, MAXTOR 7080S, SEAGATE ST157N
23		- Should support most tape drives. The drives that are
24		  currently tested are:
25			TANDBERG 3600
26		- Should support most CD-ROM drives.
27	- The buildin video controller
28	- The building (720Kb/1.44Mb) floppydrive
29	- The serial2/modem2 ports
30	- The Falcon FX memory expansion
31	- The atari mouse
32
33If its not on this list, there is no support for it in this release.
34