. .Nx*M \*V runs on Motorola .Tn MVME147 No and MVME167 No Single Board Computers.
p The minimal configuration requires 4 MB of RAM and ~100 MB of disk space. To install the entire system requires much more disk space (approx. 200 MB additional space is necessary for full sources. Double that if you want to recompile it all!). To run X (clients only) or compile the system, more RAM is recommended. Good performance requires 8 MB of RAM, or 16 MB when running the X Window System.
p Here is a table of recommended HD partition sizes for a full install: l -column -offset indent Partition Suggested Needed t Partition Ta Suggested Ta Needed t / (root) Ta "20 MB" Ta "12 MB" t /usr Ta "100 MB" Ta "80 MB" t /var Ta "20 MB" Ta "5 MB" t swap Ta Em "2-3 *RAM" Ta 6 MB .El .(item -offset indent Anything else is up to you! .item)
p Note that the .Nx*M installation procedure uses a .Em miniroot image which is placed into the swap area of the disk. The swap partition must be large enough to hold this miniroot image (\*> 6 MB). . .Ss2 Supported VME147 hardware .(bullet -offset indent Serial ports (RS232) .(bullet -compact built-in console t ttyZ1 t ttyZ2 t ttyZ3 .bullet) t Parallel port .(bullet -compact On-board centronics style printer port .bullet) t Network interfaces: .(bullet -compact On-board Lance Ethernet (le) .bullet) t SCSI .(bullet -compact Most SCSI disks, tapes, CD-ROMs, etc t On-board wd33c93 SCSI bus interface chip (async only for now) .bullet) t Miscellaneous: .(bullet -compact Battery-backed real-time clock t VMEbus RAM cards .bullet) .bullet) . .Ss2 Supported VME167 hardware .(bullet -offset indent Serial ports (RS232) .(bullet -compact built-in console t ttyZ1 t ttyZ2 t ttyZ3 .bullet) t Parallel port .(bullet -compact On-board centronics style printer port .bullet) t Network interfaces: .(bullet -compact On-board Lance Ethernet (ie) .bullet) t SCSI .(bullet -compact Most SCSI disks, tapes, CD-ROMs, etc t On-board ncr53c710 SCSI I/O Processor chip .bullet) t Miscellaneous: .(bullet -compact Battery-backed real-time clock .bullet) .bullet) .
p If it's not on the above lists, there is no support for it in this release.