OpenGrok

1.1  scw mvme68k machines usually need little or no preparation before installing
1.1  scw NetBSD, other than the usual, well advised precaution of BACKING UP
1.1  scw ALL DATA on any attached storage devices.
1.1  scw
1.1  scw The following instructions should make your machine "NetBSD Ready".
1.1  scw
1.1  scw Power-up your VME147. You should have the "bug" prompt:
1.1  scw
1.1  scw         COLD Start
1.1  scw
1.1  scw         Onboard  RAM start = $00000000,  stop = $007FFFFF
1.1  scw
1.1  scw         147-Bug>
1.1  scw
1.1  scw Make sure the value for "stop" looks ok (if you've got 8MB you should
1.1  scw have the same value as I do). Also make sure the clock is ticking:
1.1  scw
1.1  scw         147-Bug>time
1.1  scw         Sunday   12/21/29   16:25:14
1.1  scw         147-Bug>time
1.1  scw         Sunday   12/21/29   16:25:15
1.1  scw         147-Bug>
1.1  scw
1.1  scw Note that NetBSD bases it's year at 1968, and adds the year offset in
1.1  scw the VME147's real-time clock to get the current year. So the '29' here
1.1  scw equates to 1997. You may have to adjust your clock using the 'set'
1.1  scw command to comply with NetBSD's requirements. Don't worry if the
1.1  scw "Day of the week" is not correct, NetBSD doesn't use it. (Actually,
1.1  scw Motorola have acknowledged a year 2000 bug whereby the day of the week
1.1  scw doesn't get set correctly by the 147Bug PROM. IT DOES NOT AFFECT NETBSD!)
1.1  scw
1.1  scw Also make sure that your VME147's ethernet address is initialised to
1.1  scw the correct value. You'll find the address on a label on the inside of
1.1  scw the board's front panel. Enter the last five digits of the address
1.1  scw using the 'lsad' command.
1.1  scw
1.1  scw To install successfully to a local SCSI disk, you need to ensure that
1.1  scw 147Bug is aware of what targets are connected to the SCSI bus. This
1.1  scw can be done by issueing the following command:
1.1  scw
1.1  scw -->     147-Bug> iot;t
1.1  scw
1.1  scw At this point, 147Bug will scan for any attached SCSI devices. After
1.1  scw a short delay, a list of SCSI devices will be displayed. You will be
1.1  scw asked if Bug should assign LUNs to SCSI ids, to which you should
1.1  scw answer Y. You should also answer Y when asked if the information is
1.1  scw to be saved to NVRAM.
1.1  scw
1.1  scw The following installation instructions will assume that your target
1.1  scw SCSI disk drive appears at SCSI-id 0. If you have a tape drive, the
1.1  scw instructions assume is is configured for SCSI-id 5. When the RAMDISK
1.1  scw root boots, NetBSD will refer to these devices as 'sd0' and 'rst0'
1.1  scw respectively. You may wish to note these down; you'll be using them
1.1  scw a lot. :-)