. Sun3 machines usually need little or no preparation before installing NetBSD, other than the usual, well advised precaution of .Em backing up all data on any attached storage devices.
p You will need to know the .Tn SCSI target ID of the drive on which you will install .Nx . .(Note SunOS/sun3 uses confusing names for the .Tn SCSI devices: target 1 is sd2, target 2 is sd4, etc. .Note)
p It might be a good time to run the diagnostics on your Sun3. First, attach a terminal to the "ttya" serial port, then set the "Diag/Norm" switch to the Diagnostic position, and power-on the machine. The Diag. switch setting forces console interaction to occur on ttya. Note that the 3/80 has a "software" diag switch you can set at the PROM monitor prompt. To turn on diag boot mode, do: c q 70b 12 To return to normal boot mode, do: c q 70b 6 .
p The console location (ttya, ttyb, or keyboard/display) is controlled by address 0x1F in the EEPROM, which you can examine and change in the PROM monitor by entering "q1f" followed by a numeric value (or just a '.' if you don't want to change it). Console values are: .Dl 00: No default graphics display .Dl 10: No tty a (9600-N-8-1) .Dl 11: No tty b (1200-N-8-1) .Dl 20: No Color option board on P4
p