OpenGrok

hardware revision 1.4  $NetBSD: hardware,v 1.4 1999/05/07 00:15:16 ragge Exp $
.
Hardware supported by NetBSD/vax \*V includes (but may not be limited to):
l -tag -width indent -offset indent t Em CPU types: VAX 11/750, VAX 11/78{0,5}, VAX 8200/8250/8300/8350,
VAX 8600/8650, MicroVAX II, MicroVAX III,
MicroVAX 3600/3800/3900, MicroVAX 3300/3400/3500,
MicroVAX 2000/VAXstation 2000, VAXstation 3100 model 30,38,40,48,76,
MicroVAX 3100 (partly) and VAXstation 4000/60.
t Em Networking: DEUNA/DELUA Unibus ethernet, DEQNA/DELQA Q22 bus ethernet,
and LANCE chip where available.
t Em Serial lines: DHU11/DHV11/DL11/DLV11/DZ11/DZQ11/DZV11 Unibus/Q22 bus
asynchronous lines and DZ11-compatible lines on VAXstations.
t Em Disks: UDA50 Unibus MSCP controller, KDA50/RQDX1/2/3 Q22 bus
MSCP controller, KDB50 BI-bus MSCP controller, MFM and
SCSI controllers on VAXstations, RP04/05/06/07 and
RM02/03/05/80 Massbus disks, and Console RL02 on VAX 8600.
p
Some third-party controllers are also known to work, other do not.
t Em Tapes: TMSCP on Q22 bus (TK50/70, TU81), TMSCP on BI bus and
SCSI tapes on VAXstations.
t Em Floppy: RX33/RX50 on RQDX controllers. RX50 on VAX 8200.
.El
p
The minimal configuration requires 2M of RAM and ~40MB of disk space,
but the installation requires at least 4MB RAM and you probably do
not want to run with anything less than that.
p
Here is a table of recommended HD partition sizes for a full install:
p
l -column -offset indent Partition Advised Needed t Partition Ta Advised Ta Needed t root (/) Ta 20M Ta 10M t user (/usr) Ta 80M Ta 45M t swap Ta 2 or 3 * RAM .El
Anything else is up to you!