p Sockets utilizing .Tn TCP are either .Dq active or .Dq passive . Active sockets initiate connections to passive sockets. By default .Tn TCP sockets are created active; to create a passive socket the .Xr listen 2 system call must be used after binding the socket with the .Xr bind 2 system call. Only passive sockets may use the .Xr accept 2 call to accept incoming connections. Only active sockets may use the .Xr connect 2 call to initiate connections.
p Passive sockets may .Dq underspecify their location to match incoming connection requests from multiple networks. This technique, termed .Dq wildcard addressing , allows a single server to provide service to clients on multiple networks. To create a socket which listens on all networks, the Internet address .Dv INADDR_ANY must be bound. The .Tn TCP port may still be specified at this time; if the port is not specified the system will assign one. Once a connection has been established the socket's address is fixed by the peer entity's location. The address assigned the socket is the address associated with the network interface through which packets are being transmitted and received. Normally this address corresponds to the peer entity's network.
p .Tn TCP supports one socket option which is set with .Xr setsockopt 2 and tested with .Xr getsockopt 2 . Under most circumstances, .Tn TCP sends data when it is presented; when outstanding data has not yet been acknowledged, it gathers small amounts of output to be sent in a single packet once an acknowledgement is received. For a small number of clients, such as window systems that send a stream of mouse events which receive no replies, this packetization may cause significant delays. Therefore, .Tn TCP provides a boolean option, .Dv TCP_NODELAY (from .Aq Pa netinet/tcp.h , to defeat this algorithm. The option level for the .Xr setsockopt 2 call is the protocol number for .Tn TCP , available from .Xr getprotobyname 3 . In the historical x .Tn TCP implementation, if the .Dv TCP_NODELAY option was set on a passive socket, the sockets returned by .Xr accept 2 erroneously did not have the .Dv TCP_NODELAY option set; the behavior was corrected to inherit .Dv TCP_NODELAY in .Nx 1.6 .
p Options at the .Tn IP network level may be used with .Tn TCP ; see .Xr ip 4 or .Xr ip6 4 . Incoming connection requests that are source-routed are noted, and the reverse source route is used in responding. .Sh DIAGNOSTICS A socket operation may fail with one of the following errors returned: l -tag -width [EADDRNOTAVAIL] t Bq Er EISCONN when trying to establish a connection on a socket which already has one; t Bq Er ENOBUFS when the system runs out of memory for an internal data structure; t Bq Er ETIMEDOUT when a connection was dropped due to excessive retransmissions; t Bq Er ECONNRESET when the remote peer forces the connection to be closed; t Bq Er ECONNREFUSED when the remote peer actively refuses connection establishment (usually because no process is listening to the port); t Bq Er EADDRINUSE when an attempt is made to create a socket with a port which has already been allocated; t Bq Er EADDRNOTAVAIL when an attempt is made to create a socket with a network address for which no network interface exists. .El .Sh SEE ALSO .Xr getsockopt 2 , .Xr socket 2 , .Xr inet 4 , .Xr inet6 4 , .Xr intro 4 , .Xr ip 4 , .Xr ip6 4 .Rs .%R RFC .%N 793 .%D September 1981 .%T "Transmission Control Protocol" .Re .Rs .%R RFC .%N 1122 .%D October 1989 .%T "Requirements for Internet Hosts -- Communication Layers" .Re .Sh HISTORY The .Nm protocol stack appeared in x 4.2 .