xref: /src/sys/arch/amiga/conf/DRACO

# $NetBSD: DRACO,v 1.62 2002/02/15 21:28:05 is Exp $
#
# This file was automatically created. Changes will be
# lost when running make in this directory.
#
# Created from: #NetBSD: GENERIC,v 1.174 2002/02/13 12:08:57 is Exp $

#GENERIC machine description file

#This machine description file is used to generate the default NetBSD
#kernel.  The generic kernel does not include all options, subsystems
#and device drivers, but should be useful for most applications.

#The machine description file can be customised for your specific
#machine to reduce the kernel size and improve its performance.

#For further information on compiling NetBSD kernels, see the config(8)
#man page.

#For further information on hardware support for this architecture, see
#the intro(4) man page.  For further information about kernel options
#for this architecture, see the options(4) man page.  For an explanation
#of each device driver in this file see the section 4 man page for the
#device.
include "arch/amiga/conf/std.amiga"

#ident  		"GENERIC-$Revision: 1.62 $"

maxusers	8
options 	RTC_OFFSET=0

#mainboards to support (in addition to Amiga)

options 	DRACO

#processors this kernel should support

options 	M68060		# support for 060
options 	M060SP		# MC68060 software support (Required for 060)

#Networking options

options 	INET		# IP networking support (Required)
options 	INET6		# IPV6
#options 	IPSEC		# IP security
#options 	IPSEC_ESP	# IP security (encryption part; define w/IPSEC)
#options 	IPSEC_DEBUG	# debug for IP security
#options 	GATEWAY		# Packet forwarding
#options 	DIRECTED_BROADCAST	# Broadcast across subnets

#options 	MROUTING	# Multicast routing
options 	NS		# XNS
#options 	NSIP		# XNS tunneling over IP
options 	ISO,TPIP	# OSI
#options 	EON		# OSI tunneling over IP
options 	CCITT,LLC,HDLC	# X.25
options 	NETATALK	# AppleTalk networking protocols
#options 	TCP_DEBUG	# Record last TCP_NDEBUG packets with SO_DEBUG

options 	PPP_BSDCOMP	# BSD-Compress compression support for PPP
options 	PPP_DEFLATE	# Deflate compression support for PPP
options 	PPP_FILTER	# Active filter support for PPP (requires bpf)
options 	PFIL_HOOKS	# pfil(9) packet filter hooks
options 	IPFILTER_LOG	# ipmon(8) log support

file-system 	FFS		# Berkeley fast file system
file-system 	EXT2FS		# second extended file system (linux)
#file-system 	LFS		# log-structured filesystem (experimental)

file-system 	MFS		# Memory based filesystem

file-system 	NFS		# Network File System client side code
file-system 	ADOSFS		# AmigaDOS file system
file-system 	CD9660		# ISO 9660 + Rock Ridge filesystem
file-system 	MSDOSFS		# MS-DOS filesystem

file-system 	KERNFS		# kernel data-structure filesystem

file-system 	FDESC		# user file descriptor filesystem
file-system 	NULLFS		# loopback filesystem
file-system 	OVERLAY		# overlay filesystem
#file-system 	PORTAL		# Portal filesystem
file-system 	PROCFS		# /proc filesystem
file-system 	UMAPFS		# NULLFS + uid and gid remapping
file-system 	UNION		# union filesystem

#Filesystem options

#options 	FFS_EI		# FFS Endian Independant support

options 	QUOTA		# User and group quotas in FFS
options 	SOFTDEP		# FFS soft updates support.
options 	NFSSERVER	# Network File System server side code

#options 	EXT2FS_SYSTEM_FLAGS # makes ext2fs file flags (append and
				# immutable) behave as system flags.

#Compatibility options for various existing systems

#options 	TCP_COMPAT_42	# 4.2BSD TCP/IP bug compat. Not recommended.
options 	COMPAT_43	# compatibility with 4.3BSD interfaces
options 	COMPAT_09	# compatibility with NetBSD 0.9
options 	COMPAT_10	# compatibility with NetBSD 1.0
options 	COMPAT_12	# compatibility with NetBSD 1.2
options 	COMPAT_13	# compatibility with NetBSD 1.3
options 	COMPAT_14	# compatibility with NetBSD 1.4
options 	COMPAT_SUNOS	# Support to run Sun (m68k) executables
options 	COMPAT_SVR4	# Support to run SVR4 (m68k) executables
options 	COMPAT_NOMID	# allow nonvalid machine id executables
#options 	COMPAT_LINUX	# Support to run Linux/m68k executables

options 	EXEC_AOUT	# 32-bit aout executables (NetBSD-1.5.x)
options 	COMPAT_AOUT_M68K # actually make some system calls work.

#Support for System V IPC facilities.

options 	SYSVSHM		# System V-like shared memory
options 	SYSVMSG		# System V-like messages
options 	SYSVSEM		# System V-like semaphores
#options 	SEMMNI=10	# number of semaphore identifiers
#options 	SEMMNS=60	# number of semaphores in system
#options 	SEMUME=10	# max number of undo entries per process
#options 	SEMMNU=30	# number of undo structures in system

#Support for various kernel options

options 	KTRACE		# system call tracing support
options 	LKM		# Loadable kernel modules
options 	UCONSOLE	# anyone can redirect a virtual console

#options 	INSECURE	# disable kernel security levels
options 	SCSIVERBOSE	# human readable SCSI error messages

options 	NTP		# NTP phase/frequency locked loop
#options	PIPE_SOCKETPAIR	# smaller, but slower pipe(2)

#Misc. debugging options

options 	DDB		# Kernel debugger
#options 	DDB_HISTORY_SIZE=100	# Enable history editing in DDB
options 	DIAGNOSTIC	# Extra kernel sanity checks
#options 	DEBUG		# Enable misc. kernel debugging code
#options 	SYSCALL_DEBUG	# debug all syscalls.
#options 	SCSIDEBUG	# Add SCSI debugging statements
#options 	PANICBUTTON	# Forced crash via keypress (???)

#Amiga specific options

#options 	LIMITMEM=24	# Do not use more than LIMITMEM MB of the
				# first bank of RAM. (default: unlimited)
#options 	NKPTADD=4	# set this for 4 additional KPT pages
#options 	NKPTADDSHIFT=24	# set this for 1 additional KPT page
				# per 16 MB (1<<24 bytes) of RAM
				# uncomment and decrease this, or uncomment and
				# increase NKPTADD if you get "out of PT pages"
				# panics.

#ATTENTION: There is NO WARRANTY AT ALL that the sync will be complete
#before the 10 secondinterval ends, or that KBDRESET does work at all.
#options 	KBDRESET	# sync on Ctrl-Amiga-Amiga

#These options improve performance with the built-in serial port
#on slower Amigas.  Try the larger buffers first then lev6_defer.
#options 	SERIBUF_SIZE=4096
#options 	SEROBUF_SIZE=32
#options 	LEV6_DEFER	# defers l6 to l4 (below serial l5)

options 	RETINACONSOLE	# enable code to allow retina to be console

#options 	KFONT_8X11	# 8x11 font

#This is how you would tell the kernel the A2410 oscillator frequencies:
#The used frequencies are the defaults, and do not need option setting
#options 	ULOWELL_OSC1=36000000
#options 	ULOWELL_OSC2=66667000

#This is how you specify the blitting speed, higher values may speed up blits
#a littel bit.  If you raise this value too much some trash may appear.
#the commented version is the default.
#options 	RH_MEMCLK=61000000
#this option enables the 64 bit sprite which does not work
#for quite a few people.  E.g. The cursor sprite will turn to a block
#when moved to the top of the screen in X.
#options 	RH_64BIT_SPRITE
#enables fast scroll code appears to now work on 040 systems.
#options 	RETINA_SPEED_HACK
#enables the Hardwarecursor which does not work on some systems.
#options 	RH_HARDWARECURSOR

grfrh0		at zbus0		# retina III

grf2		at grfrh0

ite2		at grf2			# terminal emulators for grfs

msc0		at zbus0		# A2232 MSC multiport serial.
mfc0		at zbus0		# MultiFaceCard I/O board
mfcs0		at mfc0 unit 0		# MFC serial
mfcs1		at mfc0 unit 1		# MFC serial
#mfcp0		at mfc0 unit 0		# MFC parallel [not available yet]
#mfc1		at zbus0		# MultiFaceCard 2nd I/O board
#mfcs2		at mfc1 unit 0
#mfcs3		at mfc1 unit 1
#mfcp1		at mfc1 unit 0

hyper*		at zbus?		# zbus HyperCom3/3+/4/4+
#hyper*		at mainbus0		# not yet: HyperCom1 + HyperCom3
com*		at hyper? port ?	# Hypercom3/4 serial ports
lpt*		at hyper? port ?	# Hypercom3+/4+ parallel port

#options 	IOBZCLOCK=22118400 	# default, uncomment the next line
#options 	IOBZCLOCK=24000000	# if needed.

iobl*		at zbus?		# zbus IOBlix
com*		at iobl? port ?		# IOBlix serial ports
lpt*		at iobl? port ?		# IOBlix parallel ports

#Keyboard device. Optionally can attach a wskbd.
#wskbd works together with a wsdisplay so enable them both if you will.
#Don't enable wskbd if you use ite.

#XXX in std.amiga: kbd0 at mainbus0
#wskbd0		at kbd0 console ?

#DraCo Mainboard devices (sans keyboard)

drbbc0		at mainbus0		# DraCo battery backed clock
drsupio0	at mainbus0		# DraCo superio chip
com*		at drsupio? port ?	# DraCo serial
lpt0		at drsupio? port ?	# DraCo parallel

#Zorro-II, Zorro-III, DraCo Direct-Bus devices (sans graphics)

repulse*	at zbus0		# ALiENDESiGN Repulse
audio*		at repulse?

toccata*	at zbus0		# MacroSystem GmbH Toccata
audio*		at toccata?

#Ethernet cards:
le*		at zbus0		# A2065, Ameristar, Ariadne
ne*		at zbus0		# AriadneII, X-surf
ed*		at zbus0		# Hydra, ASDG LanRover
es*		at zbus0		# CEI A4066 EthernetPLUS
qn*		at zbus0		# Quicknet

bah*		at zbus0		# C=/Ameristar A2060 / 560

drsc0		at mainbus0		# DraCo scsi
scsibus*	at drsc0

#each hard drive from low target to high
#will configure to the next available sd unit number
sd*	at scsibus? target ? lun ?	# scsi disks
st*	at scsibus? target ? lun ?	# scsi tapes
cd*	at scsibus? target ? lun ?	# scsi cds
ch*	at scsibus? target ? lun ?	# scsi autochangers

ss*	at scsibus? target ? lun ?	# scsi scanner
uk*	at scsibus? target ? lun ?	# scsi unknown

pseudo-device	loop			# loopback network interface
pseudo-device	sl		1	# SLIP network interfaces
pseudo-device	ppp		1	# PPP network interfaces
pseudo-device	pppoe			# PPP over Ethernet (RFC 2516)
pseudo-device	tun		1	# network tunnel line discipline
#pseudo-device	gre		2	# generic L3 over IP tunnel
#pseudo-device	ipip		2	# IP Encapsulation within IP (RFC 2003)
pseudo-device	bpfilter	16	# Berkeley packet filter
pseudo-device	ipfilter		# IP Filter package
pseudo-device	gif		4	# IPv[46] over IPv[46] tunnel (RFC1933)
#pseudo-device	faith		1	# IPv[46] tcp relay translation i/f
#pseudo-device	stf		1	# 6to4 IPv6 over IPv4 encapsulation
pseudo-device	vlan			# IEEE 802.1q encapsulation
pseudo-device	bridge			# simple inter-network bridging

pseudo-device	view		4	# views (needed for grfcc)
pseudo-device	pty			# pseudo-terminals

pseudo-device	vnd		4	# vnode pseudo-disks
pseudo-device	ccd		4	# concatenated disk devices
pseudo-device	raid		8	# RAIDframe disk driver
options 	RAID_AUTOCONFIG		# auto-configuration of RAID components
#Options to enable various other RAIDframe RAID types.
#options	RF_INCLUDE_EVENODD=1
#options	RF_INCLUDE_RAID5_RS=1
#options	RF_INCLUDE_PARITYLOGGING=1
#options	RF_INCLUDE_CHAINDECLUSTER=1
#options	RF_INCLUDE_INTERDECLUSTER=1
#options 	RF_INCLUDE_PARITY_DECLUSTERING=1
#options	RF_INCLUDE_PARITY_DECLUSTERING_DS=1

pseudo-device	rnd			# /dev/random and in-kernel generator
#options 	RND_COM			# use "com" randomness as well (BROKEN)

config	netbsd root on ? type ?