DRACO revision 1.63
1# $NetBSD: DRACO,v 1.63 2002/03/04 13:24:08 sommerfeld Exp $ 2# 3# This file was automatically created. Changes will be 4# lost when running make in this directory. 5# 6# Created from: #NetBSD: GENERIC,v 1.174 2002/02/13 12:08:57 is Exp $ 7 8#GENERIC machine description file 9 10#This machine description file is used to generate the default NetBSD 11#kernel. The generic kernel does not include all options, subsystems 12#and device drivers, but should be useful for most applications. 13 14#The machine description file can be customised for your specific 15#machine to reduce the kernel size and improve its performance. 16 17#For further information on compiling NetBSD kernels, see the config(8) 18#man page. 19 20#For further information on hardware support for this architecture, see 21#the intro(4) man page. For further information about kernel options 22#for this architecture, see the options(4) man page. For an explanation 23#of each device driver in this file see the section 4 man page for the 24#device. 25include "arch/amiga/conf/std.amiga" 26 27#ident "GENERIC-$Revision: 1.63 $" 28 29maxusers 8 30options RTC_OFFSET=0 31 32#mainboards to support (in addition to Amiga) 33 34options DRACO 35 36#processors this kernel should support 37 38options M68060 # support for 060 39options M060SP # MC68060 software support (Required for 060) 40 41#Networking options 42 43options INET # IP networking support (Required) 44options INET6 # IPV6 45#options IPSEC # IP security 46#options IPSEC_ESP # IP security (encryption part; define w/IPSEC) 47#options IPSEC_DEBUG # debug for IP security 48#options GATEWAY # Packet forwarding 49#options DIRECTED_BROADCAST # Broadcast across subnets 50 51#options MROUTING # Multicast routing 52options NS # XNS 53#options NSIP # XNS tunneling over IP 54options ISO,TPIP # OSI 55#options EON # OSI tunneling over IP 56options CCITT,LLC,HDLC # X.25 57options NETATALK # AppleTalk networking protocols 58#options TCP_DEBUG # Record last TCP_NDEBUG packets with SO_DEBUG 59 60options PPP_BSDCOMP # BSD-Compress compression support for PPP 61options PPP_DEFLATE # Deflate compression support for PPP 62options PPP_FILTER # Active filter support for PPP (requires bpf) 63options PFIL_HOOKS # pfil(9) packet filter hooks 64options IPFILTER_LOG # ipmon(8) log support 65 66file-system FFS # Berkeley fast file system 67file-system EXT2FS # second extended file system (linux) 68#file-system LFS # log-structured filesystem (experimental) 69 70file-system MFS # Memory based filesystem 71 72file-system NFS # Network File System client side code 73file-system ADOSFS # AmigaDOS file system 74file-system CD9660 # ISO 9660 + Rock Ridge filesystem 75file-system MSDOSFS # MS-DOS filesystem 76 77file-system KERNFS # kernel data-structure filesystem 78 79file-system FDESC # user file descriptor filesystem 80file-system NULLFS # loopback filesystem 81file-system OVERLAY # overlay filesystem 82#file-system PORTAL # Portal filesystem 83file-system PROCFS # /proc filesystem 84file-system UMAPFS # NULLFS + uid and gid remapping 85file-system UNION # union filesystem 86 87#Filesystem options 88 89#options FFS_EI # FFS Endian Independant support 90 91options QUOTA # User and group quotas in FFS 92options SOFTDEP # FFS soft updates support. 93options NFSSERVER # Network File System server side code 94 95#options EXT2FS_SYSTEM_FLAGS # makes ext2fs file flags (append and 96 # immutable) behave as system flags. 97 98#Compatibility options for various existing systems 99 100#options TCP_COMPAT_42 # 4.2BSD TCP/IP bug compat. Not recommended. 101options COMPAT_43 # compatibility with 4.3BSD interfaces 102options COMPAT_09 # compatibility with NetBSD 0.9 103options COMPAT_10 # compatibility with NetBSD 1.0 104options COMPAT_12 # compatibility with NetBSD 1.2 105options COMPAT_13 # compatibility with NetBSD 1.3 106options COMPAT_14 # compatibility with NetBSD 1.4 107options COMPAT_SUNOS # Support to run Sun (m68k) executables 108options COMPAT_SVR4 # Support to run SVR4 (m68k) executables 109options COMPAT_NOMID # allow nonvalid machine id executables 110#options COMPAT_LINUX # Support to run Linux/m68k executables 111 112options EXEC_AOUT # 32-bit aout executables (NetBSD-1.5.x) 113options COMPAT_AOUT_M68K # actually make some system calls work. 114 115#Support for System V IPC facilities. 116 117options SYSVSHM # System V-like shared memory 118options SYSVMSG # System V-like messages 119options SYSVSEM # System V-like semaphores 120#options SEMMNI=10 # number of semaphore identifiers 121#options SEMMNS=60 # number of semaphores in system 122#options SEMUME=10 # max number of undo entries per process 123#options SEMMNU=30 # number of undo structures in system 124 125#Support for various kernel options 126 127options KTRACE # system call tracing support 128options LKM # Loadable kernel modules 129options UCONSOLE # anyone can redirect a virtual console 130 131#options INSECURE # disable kernel security levels 132options SCSIVERBOSE # human readable SCSI error messages 133 134options NTP # NTP phase/frequency locked loop 135#options PIPE_SOCKETPAIR # smaller, but slower pipe(2) 136 137#Misc. debugging options 138 139options DDB # Kernel debugger 140#options DDB_HISTORY_SIZE=100 # Enable history editing in DDB 141options DIAGNOSTIC # Extra kernel sanity checks 142#options DEBUG # Enable misc. kernel debugging code 143#options SYSCALL_DEBUG # debug all syscalls. 144#options SCSIDEBUG # Add SCSI debugging statements 145#options PANICBUTTON # Forced crash via keypress (???) 146 147#Amiga specific options 148 149#options LIMITMEM=24 # Do not use more than LIMITMEM MB of the 150 # first bank of RAM. (default: unlimited) 151#options NKPTADD=4 # set this for 4 additional KPT pages 152#options NKPTADDSHIFT=24 # set this for 1 additional KPT page 153 # per 16 MB (1<<24 bytes) of RAM 154 # uncomment and decrease this, or uncomment and 155 # increase NKPTADD if you get "out of PT pages" 156 # panics. 157 158#ATTENTION: There is NO WARRANTY AT ALL that the sync will be complete 159#before the 10 secondinterval ends, or that KBDRESET does work at all. 160#options KBDRESET # sync on Ctrl-Amiga-Amiga 161 162#These options improve performance with the built-in serial port 163#on slower Amigas. Try the larger buffers first then lev6_defer. 164#options SERIBUF_SIZE=4096 165#options SEROBUF_SIZE=32 166#options LEV6_DEFER # defers l6 to l4 (below serial l5) 167 168options RETINACONSOLE # enable code to allow retina to be console 169 170#options KFONT_8X11 # 8x11 font 171 172#This is how you would tell the kernel the A2410 oscillator frequencies: 173#The used frequencies are the defaults, and do not need option setting 174#options ULOWELL_OSC1=36000000 175#options ULOWELL_OSC2=66667000 176 177#This is how you specify the blitting speed, higher values may speed up blits 178#a littel bit. If you raise this value too much some trash may appear. 179#the commented version is the default. 180#options RH_MEMCLK=61000000 181#this option enables the 64 bit sprite which does not work 182#for quite a few people. E.g. The cursor sprite will turn to a block 183#when moved to the top of the screen in X. 184#options RH_64BIT_SPRITE 185#enables fast scroll code appears to now work on 040 systems. 186#options RETINA_SPEED_HACK 187#enables the Hardwarecursor which does not work on some systems. 188#options RH_HARDWARECURSOR 189 190grfrh0 at zbus0 # retina III 191 192grf2 at grfrh0 193 194ite2 at grf2 # terminal emulators for grfs 195 196msc0 at zbus0 # A2232 MSC multiport serial. 197mfc0 at zbus0 # MultiFaceCard I/O board 198mfcs0 at mfc0 unit 0 # MFC serial 199mfcs1 at mfc0 unit 1 # MFC serial 200#mfcp0 at mfc0 unit 0 # MFC parallel [not available yet] 201#mfc1 at zbus0 # MultiFaceCard 2nd I/O board 202#mfcs2 at mfc1 unit 0 203#mfcs3 at mfc1 unit 1 204#mfcp1 at mfc1 unit 0 205 206hyper* at zbus? # zbus HyperCom3/3+/4/4+ 207#hyper* at mainbus0 # not yet: HyperCom1 + HyperCom3 208com* at hyper? port ? # Hypercom3/4 serial ports 209lpt* at hyper? port ? # Hypercom3+/4+ parallel port 210 211#options IOBZCLOCK=22118400 # default, uncomment the next line 212#options IOBZCLOCK=24000000 # if needed. 213 214iobl* at zbus? # zbus IOBlix 215com* at iobl? port ? # IOBlix serial ports 216lpt* at iobl? port ? # IOBlix parallel ports 217 218#Keyboard device. Optionally can attach a wskbd. 219#wskbd works together with a wsdisplay so enable them both if you will. 220#Don't enable wskbd if you use ite. 221 222#XXX in std.amiga: kbd0 at mainbus0 223#wskbd0 at kbd0 console ? 224 225#DraCo Mainboard devices (sans keyboard) 226 227drbbc0 at mainbus0 # DraCo battery backed clock 228drsupio0 at mainbus0 # DraCo superio chip 229com* at drsupio? port ? # DraCo serial 230lpt0 at drsupio? port ? # DraCo parallel 231 232#Zorro-II, Zorro-III, DraCo Direct-Bus devices (sans graphics) 233 234repulse* at zbus0 # ALiENDESiGN Repulse 235audio* at repulse? 236 237toccata* at zbus0 # MacroSystem GmbH Toccata 238audio* at toccata? 239 240#Ethernet cards: 241le* at zbus0 # A2065, Ameristar, Ariadne 242ne* at zbus0 # AriadneII, X-surf 243ed* at zbus0 # Hydra, ASDG LanRover 244es* at zbus0 # CEI A4066 EthernetPLUS 245qn* at zbus0 # Quicknet 246 247bah* at zbus0 # C=/Ameristar A2060 / 560 248 249drsc0 at mainbus0 # DraCo scsi 250scsibus* at drsc0 251 252#each hard drive from low target to high 253#will configure to the next available sd unit number 254sd* at scsibus? target ? lun ? # scsi disks 255st* at scsibus? target ? lun ? # scsi tapes 256cd* at scsibus? target ? lun ? # scsi cds 257ch* at scsibus? target ? lun ? # scsi autochangers 258 259ss* at scsibus? target ? lun ? # scsi scanner 260uk* at scsibus? target ? lun ? # scsi unknown 261 262pseudo-device loop # loopback network interface 263pseudo-device sl 1 # SLIP network interfaces 264pseudo-device ppp 1 # PPP network interfaces 265pseudo-device pppoe # PPP over Ethernet (RFC 2516) 266pseudo-device tun 1 # network tunnel line discipline 267#pseudo-device gre 2 # generic L3 over IP tunnel 268pseudo-device bpfilter 16 # Berkeley packet filter 269pseudo-device ipfilter # IP Filter package 270pseudo-device gif 4 # IPv[46] over IPv[46] tunnel (RFC1933) 271#pseudo-device faith 1 # IPv[46] tcp relay translation i/f 272#pseudo-device stf 1 # 6to4 IPv6 over IPv4 encapsulation 273pseudo-device vlan # IEEE 802.1q encapsulation 274pseudo-device bridge # simple inter-network bridging 275 276pseudo-device view 4 # views (needed for grfcc) 277pseudo-device pty # pseudo-terminals 278 279pseudo-device vnd 4 # vnode pseudo-disks 280pseudo-device ccd 4 # concatenated disk devices 281pseudo-device raid 8 # RAIDframe disk driver 282options RAID_AUTOCONFIG # auto-configuration of RAID components 283#Options to enable various other RAIDframe RAID types. 284#options RF_INCLUDE_EVENODD=1 285#options RF_INCLUDE_RAID5_RS=1 286#options RF_INCLUDE_PARITYLOGGING=1 287#options RF_INCLUDE_CHAINDECLUSTER=1 288#options RF_INCLUDE_INTERDECLUSTER=1 289#options RF_INCLUDE_PARITY_DECLUSTERING=1 290#options RF_INCLUDE_PARITY_DECLUSTERING_DS=1 291 292pseudo-device rnd # /dev/random and in-kernel generator 293#options RND_COM # use "com" randomness as well (BROKEN) 294 295config netbsd root on ? type ? 296