xref: /src/sys/arch/evbarm/conf/CP3100

#	$NetBSD: CP3100,v 1.14 2009/10/11 16:20:22 bsh Exp $
#
#	CP3100 -- Certance CP3100 Kernel
#

include	"arch/evbarm/conf/std.cp3100"

#options 	INCLUDE_CONFIG_FILE	# embed config file in kernel binary

# estimated number of users

maxusers	32

# Standard system options

options 	RTC_OFFSET=0	# hardware clock is this many mins. west of GMT
options 	NTP		# NTP phase/frequency locked loop
#options 	NMBCLUSTERS=1024

# CPU options

# For XScale systems
options 	CPU_XSCALE_80321	# Support the XScale core
makeoptions	CPUFLAGS="-mcpu=xscale"

# Architecture options
options 	XSCALE_CACHE_READ_WRITE_ALLOCATE
#options 	HZ=512

# File systems

file-system	FFS		# UFS
file-system	LFS		# log-structured file system
file-system	MFS		# memory file system
file-system	NFS		# Network file system
#file-system 	ADOSFS		# AmigaDOS-compatible file system
#file-system 	EXT2FS		# second extended file system (linux)
#file-system	CD9660		# ISO 9660 + Rock Ridge file system
#file-system	MSDOSFS		# MS-DOS file system
file-system	FDESC		# /dev/fd
file-system	KERNFS		# /kern
file-system	NULLFS		# loopback file system
#file-system	PORTAL		# portal filesystem (still experimental)
file-system	PROCFS		# /proc
#file-system	UMAPFS		# NULLFS + uid and gid remapping
#file-system	UNION		# union file system
file-system	PTYFS		# /dev/pts/N support

# File system options
#options 	QUOTA		# UFS quotas
#options 	FFS_EI		# FFS Endian Independant support
options 	NFSSERVER
options 	WAPBL		# File system journaling support - Experimental
#options 	FFS_NO_SNAPSHOT	# No FFS snapshot support

# Networking options

options 	GATEWAY		# packet forwarding
options 	INET		# IP + ICMP + TCP + UDP
options 	INET6		# IPV6
#options 	IPSEC		# IP security
#options 	IPSEC_ESP	# IP security (encryption part; define w/ IPSEC)
#options 	IPSEC_NAT_T	# IPsec NAT traversal (NAT-T)
#options 	IPSEC_DEBUG	# debug for IP security
#options 	MROUTING	# IP multicast routing
#options 	PIM		# Protocol Independent Multicast
#options 	NS		# XNS
#options 	NSIP		# XNS tunneling over IP
#options 	ISO,TPIP	# OSI
#options 	EON		# OSI tunneling over IP
#options 	CCITT,LLC,HDLC	# X.25
#options 	NETATALK	# AppleTalk networking
#options 	PFIL_HOOKS	# pfil(9) packet filter hooks
#options 	PPP_BSDCOMP	# BSD-Compress compression support for PPP
#options 	PPP_DEFLATE	# Deflate compression support for PPP
#options 	PPP_FILTER	# Active filter support for PPP (requires bpf)
options 	IPFILTER_LOG	# ipmon(8) log support
options 	IPFILTER_LOOKUP	# ippool(8) support
#options 	TCP_DEBUG	# Record last TCP_NDEBUG packets with SO_DEBUG

options 	NFS_BOOT_BOOTP
options 	NFS_BOOT_DHCP
#options 	NFS_BOOT_BOOTPARAM

# Compatibility options

#options 	COMPAT_43	# 4.3BSD compatibility.
options 	COMPAT_50	# NetBSD 5.0 compatibility.
#options 	COMPAT_40	# NetBSD 4.0 compatibility.
#options 	COMPAT_30	# NetBSD 3.0 compatibility.
#options 	COMPAT_20	# NetBSD 2.0 compatibility.
#options 	COMPAT_16	# NetBSD 1.6 compatibility.
#options 	COMPAT_15	# NetBSD 1.5 compatibility.
#options 	COMPAT_14	# NetBSD 1.4 compatibility.
#options 	COMPAT_13	# NetBSD 1.3 compatibility.
#options 	COMPAT_12	# NetBSD 1.2 compatibility.
#options 	COMPAT_11	# NetBSD 1.1 compatibility.
#options 	COMPAT_10	# NetBSD 1.0 compatibility.
#options 	COMPAT_09	# NetBSD 0.9 compatibility.
#options 	TCP_COMPAT_42	# 4.2BSD TCP/IP bug compat. Not recommended.
options 	COMPAT_BSDPTY	# /dev/[pt]ty?? ptys.

# Shared memory options

options 	SYSVMSG		# System V-like message queues
options 	SYSVSEM		# System V-like semaphores
#options 	SEMMNI=10	# number of semaphore identifiers
#options 	SEMMNS=60	# number of semaphores in system
#options 	SEMUME=10	# max number of undo entries per process
#options 	SEMMNU=30	# number of undo structures in system
options 	SYSVSHM		# System V-like memory sharing
options 	P1003_1B_SEMAPHORE	# p1003.1b semaphore support

# Device options

#options 	MEMORY_DISK_HOOKS	# boottime setup of ramdisk
#options 	MEMORY_DISK_ROOT_SIZE=3400	# Size in blocks
#options 	MEMORY_DISK_IS_ROOT	# use memory disk as root

# Console options.  The default console is speed is 115200 baud.
options 	CONSPEED=115200		# Console speed

# Miscellaneous kernel options
options 	KTRACE		# system call tracing, a la ktrace(1)
options 	IRQSTATS	# manage IRQ statistics
#options 	KMEMSTATS	# kernel memory statistics
#options 	SCSIVERBOSE	# Verbose SCSI errors
#options 	PCIVERBOSE	# Verbose PCI descriptions
#options 	MIIVERBOSE	# Verbose MII autoconfuration messages
#options 	PCI_CONFIG_DUMP	# verbosely dump PCI config space
#options 	DDB_KEYCODE=0x40
options 	USERCONF	# userconf(4) support
#options	PIPE_SOCKETPAIR	# smaller, but slower pipe(2)
#options 	SYSCTL_INCLUDE_DESCR	# Include sysctl descriptions in kernel

# Development and Debugging options

options 	PERFCTRS	# performance counters
options 	DIAGNOSTIC	# internally consistency checks
#options 	DEBUG
#options 	PMAP_DEBUG	# Enable pmap_debug_level code
#options 	VERBOSE_INIT_ARM # verbose bootstraping messages
options 	DDB		# in-kernel debugger
options 	DDB_HISTORY_SIZE=100	# Enable history editing in DDB
#makeoptions	DEBUG="-g"	# compile full symbol table
options 	SYMTAB_SPACE=360000

config		netbsd		root on ? type ?
config		netbsd-wm0	root on wm0 type nfs
config		netbsd-wd0	root on wd0a type ffs
config		netbsd-sd0	root on sd0a type ffs

# The main bus device
mainbus0	at root

# The boot CPU
cpu0		at mainbus?

# On-board device support
obio*		at mainbus?

# Console UART.
# Note: "xint 4" is actually the HPI# pin
com0		at obio? addr 0xfe800000 xint 4

# i80321 I/O Processor peripheral support
iopxs*		at mainbus?

iopaau*		at iopxs?		# Application Accelerator Unit
iopiic*		at iopxs?		# I2C Controller Unit(s)
iic0		at iopiic?
iic1		at iopiic?
iopwdog*	at iopxs?		# Watchdog timer
pci0		at iopxs? bus ?		# PCI/PCI-X support

# IIC Devices
m41trtc0	at iic1 addr 0x68		# M41T11 Realtime Clock

#
# Storage devices
#

# Serial ATA: i31244
artsata*	at pci? dev ? function ?	# Intel i31244 SATA controller
atabus* 	at ata?

# ATA Disks
wd*	at atabus? drive ? flags 0x0000

# SCSI: Symbios Logic 53c1010
#
# Wire down the Target/Host instances. Disable the target contoller for
# now as we don't currently support SCSI target mode.
siop0		at pci0 dev 2 function 1	# Host controller
#siop1		at pci0 dev 2 function 0	# Target controller
scsibus*	at scsi?

# SCSI Devices
sd*	at scsibus? target ? lun ?	# SCSI disk drives
st*	at scsibus? target ? lun ?	# SCSI tape drives
cd*	at scsibus? target ? lun ?	# SCSI CD-ROM drives
ch*	at scsibus? target ? lun ?	# SCSI autochangers
ses*	at scsibus? target ? lun ?	# SCSI Enclosure Services devices
ss*	at scsibus? target ? lun ?	# SCSI Scanners
uk*	at scsibus? target ? lun ?	# SCSI unknown

#
# Networking devices
#

# PCI network devices
wm*	at pci? dev ? function ?	# Intel i82546EB Gig-E

# MII/PHY support
makphy* at mii? phy ?			# Marvell 88E1000 PHYs

# Pseudo-Devices

# disk/mass storage pseudo-devices
pseudo-device	ccd		4	# concatenated/striped disk devices
#pseudo-device	cgd		4	# cryptographic disk devices
pseudo-device	raid		8	# RAIDframe disk driver
options 	RAID_AUTOCONFIG		# auto-configuration of RAID components
# Options to enable various other RAIDframe RAID types.
#options 	RF_INCLUDE_EVENODD=1
#options 	RF_INCLUDE_RAID5_RS=1
#options 	RF_INCLUDE_PARITYLOGGING=1
#options 	RF_INCLUDE_CHAINDECLUSTER=1
#options 	RF_INCLUDE_INTERDECLUSTER=1
#options 	RF_INCLUDE_PARITY_DECLUSTERING=1
#options 	RF_INCLUDE_PARITY_DECLUSTERING_DS=1
#pseudo-device	fss		4	# file system snapshot device

#pseudo-device	md		1	# memory disk device (ramdisk)
pseudo-device	vnd			# disk-like interface to files
options 	VND_COMPRESSION		# compressed vnd(4)

# network pseudo-devices
pseudo-device	bpfilter		# Berkeley packet filter
pseudo-device	ipfilter		# IP filter (firewall) and NAT
pseudo-device	loop			# network loopback
#pseudo-device	tun			# network tunneling over tty
#pseudo-device	vlan			# IEEE 802.1q encapsulation
#pseudo-device	bridge			# simple inter-network bridging

# miscellaneous pseudo-devices
pseudo-device	pty			# pseudo-terminals
pseudo-device	rnd			# /dev/random and in-kernel generator
pseudo-device	clockctl		# user control of clock subsystem
pseudo-device	ksyms			# /dev/ksyms

# data mover pseudo-devices
#pseudo-device	swdmover		# softare dmover(9) back-end
#pseudo-device	dmoverio		# /dev/dmover dmover(9) interface