autoconf.c revision 1.8
1 /* $NetBSD: autoconf.c,v 1.8 2006/07/19 19:25:48 tsutsui Exp $ */ 2 3 /* 4 * Copyright (c) 1990, 1993 5 * The Regents of the University of California. All rights reserved. 6 * 7 * This code is derived from software contributed to Berkeley by 8 * the Systems Programming Group of the University of Utah Computer 9 * Science Department. 10 * 11 * Redistribution and use in source and binary forms, with or without 12 * modification, are permitted provided that the following conditions 13 * are met: 14 * 1. Redistributions of source code must retain the above copyright 15 * notice, this list of conditions and the following disclaimer. 16 * 2. Redistributions in binary form must reproduce the above copyright 17 * notice, this list of conditions and the following disclaimer in the 18 * documentation and/or other materials provided with the distribution. 19 * 3. Neither the name of the University nor the names of its contributors 20 * may be used to endorse or promote products derived from this software 21 * without specific prior written permission. 22 * 23 * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND 24 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 25 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 26 * ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE 27 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 28 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 29 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 30 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 31 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 32 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 33 * SUCH DAMAGE. 34 * 35 * from: Utah Hdr: autoconf.c 1.16 92/05/29 36 * 37 * @(#)autoconf.c 8.1 (Berkeley) 6/10/93 38 */ 39 /* 40 * Copyright (c) 1988 University of Utah. 41 * 42 * This code is derived from software contributed to Berkeley by 43 * the Systems Programming Group of the University of Utah Computer 44 * Science Department. 45 * 46 * Redistribution and use in source and binary forms, with or without 47 * modification, are permitted provided that the following conditions 48 * are met: 49 * 1. Redistributions of source code must retain the above copyright 50 * notice, this list of conditions and the following disclaimer. 51 * 2. Redistributions in binary form must reproduce the above copyright 52 * notice, this list of conditions and the following disclaimer in the 53 * documentation and/or other materials provided with the distribution. 54 * 3. All advertising materials mentioning features or use of this software 55 * must display the following acknowledgement: 56 * This product includes software developed by the University of 57 * California, Berkeley and its contributors. 58 * 4. Neither the name of the University nor the names of its contributors 59 * may be used to endorse or promote products derived from this software 60 * without specific prior written permission. 61 * 62 * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND 63 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 64 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 65 * ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE 66 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 67 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 68 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 69 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 70 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 71 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 72 * SUCH DAMAGE. 73 * 74 * from: Utah Hdr: autoconf.c 1.16 92/05/29 75 * 76 * @(#)autoconf.c 8.1 (Berkeley) 6/10/93 77 */ 78 79 #include <sys/param.h> 80 #include <sys/reboot.h> 81 82 #include <hp300/stand/common/samachdep.h> 83 #include <hp300/stand/common/rominfo.h> 84 #include <hp300/stand/common/device.h> 85 #include <hp300/stand/common/hpibvar.h> 86 #include <hp300/stand/common/scsireg.h> 87 #include <hp300/stand/common/scsivar.h> 88 89 #include <hp300/dev/grfreg.h> 90 #include <hp300/dev/intioreg.h> 91 92 /* 93 * Mapping of ROM MSUS types to BSD major device numbers 94 * WARNING: major numbers must match bdevsw indices in hp300/conf.c. 95 */ 96 static const char rom2mdev[] = { 97 0, 0, /* 0-1: none */ 98 6, /* 2: network device; special */ 99 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, /* 3-13: none */ 100 4, /* 14: SCSI disk */ 101 0, /* 15: none */ 102 2, /* 16: CS/80 device on HPIB */ 103 2, /* 17: CS/80 device on HPIB */ 104 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, /* 18-31: none */ 105 }; 106 107 struct hp_hw sc_table[MAXCTLRS]; 108 int cpuspeed; 109 110 static u_long msustobdev(void); 111 static void find_devs(void); 112 113 #ifdef PRINTROMINFO 114 void 115 printrominfo(void) 116 { 117 struct rominfo *rp = (struct rominfo *)ROMADDR; 118 119 printf("boottype %x, name %s, lowram %x, sysflag %x\n", 120 rp->boottype, rp->name, rp->lowram, rp->sysflag&0xff); 121 printf("rambase %x, ndrives %x, sysflag2 %x, msus %x\n", 122 rp->rambase, rp->ndrives, rp->sysflag2&0xff, rp->msus); 123 } 124 #endif 125 126 void 127 configure(void) 128 { 129 130 switch (machineid) { 131 case HP_320: 132 case HP_330: 133 case HP_340: 134 cpuspeed = MHZ_16; 135 break; 136 case HP_350: 137 case HP_360: 138 cpuspeed = MHZ_25; 139 break; 140 case HP_370: 141 cpuspeed = MHZ_33; 142 break; 143 case HP_375: 144 case HP_400: 145 cpuspeed = MHZ_50; 146 break; 147 case HP_380: 148 case HP_425: 149 cpuspeed = MHZ_25 * 2; /* XXX */ 150 break; 151 case HP_385: 152 case HP_433: 153 cpuspeed = MHZ_33 * 2; /* XXX */ 154 break; 155 default: /* assume the fastest (largest delay value) */ 156 cpuspeed = MHZ_50; 157 break; 158 } 159 find_devs(); 160 cninit(); 161 #ifdef PRINTROMINFO 162 printrominfo(); 163 #endif 164 hpibinit(); 165 scsiinit(); 166 if ((bootdev & B_MAGICMASK) != B_DEVMAGIC) 167 bootdev = msustobdev(); 168 } 169 170 /* 171 * Convert HP MSUS to a valid bootdev layout: 172 * TYPE comes from MSUS device type as mapped by rom2mdev 173 * PARTITION is set to 0 ('a') 174 * UNIT comes from MSUS unit (almost always 0) 175 * CONTROLLER comes from MSUS primary address 176 * ADAPTER comes from SCSI/HPIB driver logical unit number 177 * (passed back via unused hw_pa field) 178 */ 179 static u_long 180 msustobdev(void) 181 { 182 struct rominfo *rp = (struct rominfo *) ROMADDR; 183 u_long bdev = 0; 184 struct hp_hw *hw; 185 int sc, type, ctlr, slave, punit; 186 187 sc = (rp->msus >> 8) & 0xFF; 188 for (hw = sc_table; hw < &sc_table[MAXCTLRS]; hw++) 189 if (hw->hw_sc == sc) 190 break; 191 192 type = rom2mdev[(rp->msus >> 24) & 0x1F]; 193 ctlr = (int)hw->hw_pa; 194 slave = (rp->msus & 0xFF); 195 punit = ((rp->msus >> 16) & 0xFF); 196 197 bdev = MAKEBOOTDEV(type, ctlr, slave, punit, 0); 198 199 #ifdef PRINTROMINFO 200 printf("msus %x -> bdev %x\n", rp->msus, bdev); 201 #endif 202 return bdev; 203 } 204 205 int 206 sctoaddr(int sc) 207 { 208 209 if (sc == -1) 210 return INTIOBASE + FB_BASE; 211 if (sc == 7 && internalhpib) 212 return internalhpib ; 213 if (sc < 32) 214 return DIOBASE + sc * DIOCSIZE ; 215 if (sc >= 132) 216 return DIOIIBASE + (sc - 132) * DIOIICSIZE ; 217 return sc; 218 } 219 220 /* 221 * Probe all DIO select codes (0 - 32), the internal display address, 222 * and DIO-II select codes (132 - 256). 223 * 224 * Note that we only care about displays, LANCEs, SCSIs and HP-IBs. 225 */ 226 static void 227 find_devs(void) 228 { 229 short sc, sctop; 230 u_char *id_reg; 231 caddr_t addr; 232 struct hp_hw *hw; 233 234 hw = sc_table; 235 sctop = machineid == HP_320 ? 32 : 256; 236 for (sc = -1; sc < sctop; sc++) { 237 if (sc >= 32 && sc < 132) 238 continue; 239 addr = (caddr_t) sctoaddr(sc); 240 if (badaddr(addr)) 241 continue; 242 243 id_reg = (u_char *) addr; 244 hw->hw_pa = 0; /* XXX used to pass back LUN from driver */ 245 if (sc >= 132) 246 hw->hw_size = (id_reg[0x101] + 1) * 0x100000; 247 else 248 hw->hw_size = DIOCSIZE; 249 hw->hw_kva = addr; 250 hw->hw_id = id_reg[1]; 251 hw->hw_sc = sc; 252 253 /* 254 * Not all internal HP-IBs respond rationally to id requests 255 * so we just go by the "internal HPIB" indicator in SYSFLAG. 256 */ 257 if (sc == 7 && internalhpib) { 258 hw->hw_type = C_HPIB; 259 hw++; 260 continue; 261 } 262 263 switch (hw->hw_id) { 264 case 5: /* 98642A */ 265 case 5+128: /* 98642A remote */ 266 hw->hw_type = D_COMMDCM; 267 break; 268 case 8: /* 98625B */ 269 case 128: /* 98624A */ 270 hw->hw_type = C_HPIB; 271 break; 272 case 21: /* LANCE */ 273 hw->hw_type = D_LAN; 274 break; 275 case 57: /* Displays */ 276 hw->hw_type = D_BITMAP; 277 hw->hw_secid = id_reg[0x15]; 278 switch (hw->hw_secid) { 279 case 4: /* renaissance */ 280 case 8: /* davinci */ 281 sc++; /* occupy 2 select codes */ 282 break; 283 } 284 break; 285 case 9: 286 hw->hw_type = D_KEYBOARD; 287 break; 288 case 7: 289 case 7+32: 290 case 7+64: 291 case 7+96: 292 hw->hw_type = C_SCSI; 293 break; 294 default: /* who cares */ 295 hw->hw_type = D_MISC; 296 break; 297 } 298 hw++; 299 } 300 } 301
Indexes created Wed Sep 24 05:09:52 GMT 2025