NET4501 revision 1.92
1# $NetBSD: NET4501,v 1.92 2017/02/26 12:21:15 maya Exp $ 2# 3# NET4501 -- kernel configuration for a Soekris Engineering net4501 4# single-board computer. 5# 6# http://www.soekris.com/ 7# 8 9include "arch/i386/conf/std.i386" 10 11#options INCLUDE_CONFIG_FILE # embed config file in kernel binary 12 13#ident "NET4501-$Revision: 1.92 $" 14 15maxusers 32 # estimated number of users 16 17# AMD Elan SC520's timer runs at a different frequency 18options TIMER_FREQ=1189200 19 20makeoptions COPTS="-Os" 21 22# CPU-related options. 23#options VM86 # virtual 8086 emulation 24#options USER_LDT # user-settable LDT; used by WINE 25 26#options MTRR # memory-type range register syscall support 27#options PMC # performance-monitoring counters support 28 29# delay between "rebooting ..." message and hardware reset, in milliseconds 30#options CPURESET_DELAY=2000 31 32# This option allows you to force a serial console at the specified 33# I/O address. see console(4) for details. 34#options CONSDEVNAME="\"com\"",CONADDR=0x2f8,CONSPEED=57600 35# you don't want the option below ON iff you are using the 36# serial console option of the new boot strap code. 37#options CONS_OVERRIDE # Always use above! independent of boot info 38 39# The following options override the memory sizes passed in from the boot 40# block. Use them *only* if the boot block is unable to determine the correct 41# values. Note that the BIOS may *correctly* report less than 640k of base 42# memory if the extended BIOS data area is located at the top of base memory 43# (as is the case on most recent systems). 44#options REALBASEMEM=639 # size of base memory (in KB) 45#options REALEXTMEM=15360 # size of extended memory (in KB) 46 47# Standard system options 48 49options INSECURE # disable kernel security levels 50 51options RTC_OFFSET=0 # hardware clock is this many mins. west of GMT 52options NTP # NTP phase/frequency locked loop 53 54options KTRACE # system call tracing via ktrace(1) 55 56options SYSVMSG # System V-like message queues 57options SYSVSEM # System V-like semaphores 58#options SEMMNI=10 # number of semaphore identifiers 59#options SEMMNS=60 # number of semaphores in system 60#options SEMUME=10 # max number of undo entries per process 61#options SEMMNU=30 # number of undo structures in system 62options SYSVSHM # System V-like memory sharing 63 64options USERCONF # userconf(4) support 65#options PIPE_SOCKETPAIR # smaller, but slower pipe(2) 66#options SYSCTL_INCLUDE_DESCR # Include sysctl descriptions in kernel 67 68# Diagnostic/debugging support options 69#options DIAGNOSTIC # inexpensive kernel consistency checks 70#options DEBUG # expensive debugging checks/support 71options DDB # in-kernel debugger 72pseudo-device ksyms 73#options DDB_ONPANIC=1 # see also sysctl(7): `ddb.onpanic' 74options DDB_HISTORY_SIZE=512 # enable history editing in DDB 75#options KGDB # remote debugger 76#options KGDB_DEVNAME="\"com\"",KGDB_DEVADDR=0x3f8,KGDB_DEVRATE=9600 77#makeoptions DEBUG="-g" # compile full symbol table 78 79# Compatibility options 80options COMPAT_NOMID # NetBSD 0.8, 386BSD, and BSDI 81options COMPAT_09 # NetBSD 0.9, 82options COMPAT_10 # NetBSD 1.0, 83options COMPAT_11 # NetBSD 1.1, 84options COMPAT_12 # NetBSD 1.2 (and 386BSD and BSDI), 85options COMPAT_13 # NetBSD 1.3 (and 386BSD and BSDI), 86options COMPAT_14 # NetBSD 1.4, 87options COMPAT_15 # NetBSD 1.5, 88options COMPAT_16 # NetBSD 1.6, 89options COMPAT_20 # NetBSD 2.0, 90options COMPAT_30 # NetBSD 3.0, 91options COMPAT_40 # NetBSD 4.0, 92options COMPAT_50 # NetBSD 5.0, 93options COMPAT_60 # NetBSD 6.0, and 94options COMPAT_70 # NetBSD 7.0 binary compatibility. 95options COMPAT_43 # 4.3BSD, 386BSD, and BSDI compatibility. 96options COMPAT_386BSD_MBRPART # recognize old partition ID 97#options TCP_COMPAT_42 # 4.2BSD TCP/IP bug compat. Not recommended. 98 99#options COMPAT_SVR4 # binary compatibility with SVR4 100#options COMPAT_IBCS2 # binary compatibility with SCO and ISC 101#options COMPAT_LINUX # binary compatibility with Linux 102#options COMPAT_FREEBSD # binary compatibility with FreeBSD 103options COMPAT_BSDPTY # /dev/[pt]ty?? ptys. 104 105# File systems 106file-system FFS # UFS 107#file-system EXT2FS # second extended file system (linux) 108#file-system LFS # log-structured file system 109file-system MFS # memory file system 110file-system NFS # Network File System client 111#file-system NTFS # Windows/NT file system (experimental) 112#file-system CD9660 # ISO 9660 + Rock Ridge file system 113#file-system MSDOSFS # MS-DOS file system 114file-system FDESC # /dev/fd 115file-system KERNFS # /kern 116#file-system NULLFS # loopback file system 117#file-system OVERLAY # overlay file system 118file-system PROCFS # /proc 119#file-system UMAPFS # NULLFS + uid and gid remapping 120#file-system UNION # union file system 121#file-system CODA # Coda File System; also needs vcoda (below) 122file-system PTYFS # /dev/pts/N support 123#file-system TMPFS # Efficient memory file-system 124 125# File system options 126#options QUOTA # legacy UFS quotas 127#options QUOTA2 # new, in-filesystem UFS quotas 128#options FFS_EI # FFS Endian Independent support 129#options FFS_NO_SNAPSHOT # No FFS snapshot support 130#options NFSSERVER # Network File System server 131#options EXT2FS_SYSTEM_FLAGS # makes ext2fs file flags (append and 132 # immutable) behave as system flags. 133 134# Networking options 135options GATEWAY # packet forwarding 136options INET # IP + ICMP + TCP + UDP 137options INET6 # IPv6 138#options IPSEC # IP security 139#options IPSEC_DEBUG # debug for IP security 140options MROUTING # IP multicast routing 141options PIM # Protocol Independent Multicast 142#options NETATALK # AppleTalk networking protocols 143#options PPP_BSDCOMP # BSD-Compress compression support for PPP 144#options PPP_DEFLATE # Deflate compression support for PPP 145#options PPP_FILTER # Active filter support for PPP (requires bpf) 146#options IPFILTER_LOG # ipmon(8) log support 147#options IPFILTER_LOOKUP # ippool(8) support 148#options TCP_DEBUG # Record last TCP_NDEBUG packets with SO_DEBUG 149 150# These options enable verbose messages for several subsystems. 151# Warning, these may compile large string tables into the kernel! 152#options MIIVERBOSE # verbose PHY autoconfig messages 153#options PCIVERBOSE # verbose PCI device autoconfig messages 154#options PCI_CONFIG_DUMP # verbosely dump PCI config space 155 156options NFS_BOOT_DHCP,NFS_BOOT_BOOTPARAM 157 158# Kernel root file system and dump configuration. 159config netbsd root on ? type ? 160#config netbsd root on sd0a type ffs 161#config netbsd root on ? type nfs 162 163# 164# Device configuration 165# 166 167# Basic Bus Support 168 169# PCI bus support 170pci* at elansc? bus ? 171 172# Configure PCI using BIOS information 173#options PCIBIOS # PCI BIOS support 174#options PCIBIOSVERBOSE # PCI BIOS verbose info 175#options PCI_ADDR_FIXUP # fixup PCI I/O addresses 176#options PCI_BUS_FIXUP # fixup PCI bus numbering 177#options PCI_INTR_FIXUP # fixup PCI interrupt routing 178#options PCIBIOS_IRQS_HINT=0x0a00 # PCI interrupts hint. IRQ 9 or 11 179#options PCIBIOS_INTR_GUESS # see pcibios(4) 180#options PCIINTR_DEBUG # super-verbose PCI interrupt fixup 181 182# PCI bridges 183elansc* at mainbus? bus ? # Elan SC520 System Controller 184#elanpar* at elansc? # Programmable Address Regions 185#elanpex* at elansc? # PCI Exception Instrumentation 186gpio* at elansc? 187#gpioow* at gpio? offset 6 mask 0x1 # 1-wire bus bitbanging via gpio 188#onewire* at gpioow? 189 190# 1-Wire devices 191#owtemp* at onewire? # Temperature sensors 192 193# ISA bus support 194isa0 at mainbus? 195 196# CardBus bridge support 197cbb* at pci? dev ? function ? 198cardslot* at cbb? 199 200# CardBus bus support 201cardbus* at cardslot? 202pcmcia* at cardslot? 203 204# Cardbus NICs 205ath* at cardbus? function ? # Atheros 5210/5211/5212 802.11 206atw* at cardbus? function ? # ADMtek ADM8211 (802.11) 207ral* at cardbus? function ? # Ralink RT2x60 (802.11) 208rtw* at cardbus? function ? # Realtek RTL8180 (802.11) 209 210# ISA serial interfaces 211com0 at isa? port 0x3f8 irq 4 # Standard PC serial ports 212com1 at isa? port 0x2f8 irq 3 213 214# IDE and related devices 215 216# ATA (IDE) bus support 217atabus* at ata? 218 219# ISA ST506, ESDI, and IDE controllers 220# Use flags 0x01 if you want to try to use 32bits data I/O (the driver will 221# fall back to 16bits I/O if 32bits I/O are not functional). 222# Some controllers pass the initial 32bit test, but will fail later. 223wdc0 at isa? port 0x1f0 irq 14 flags 0x00 224 225# IDE drives 226# Flags are used only with controllers that support DMA operations 227# and mode settings (e.g. some pciide controllers) 228# The lowest order four bits (rightmost digit) of the flags define the PIO 229# mode to use, the next set of four bits the DMA mode and the third set the 230# UltraDMA mode. For each set of four bits, the 3 lower bits define the mode 231# to use, and the last bit must be 1 for this setting to be used. 232# For DMA and UDMA, 0xf (1111) means 'disable'. 233# 0x0fac means 'use PIO mode 4, DMA mode 2, disable UltraDMA'. 234# (0xc=1100, 0xa=1010, 0xf=1111) 235# 0x0000 means "use whatever the drive claims to support". 236wd* at atabus? drive ? flags 0x0000 237 238# Network Interfaces 239 240# PCI network interfaces 241ath* at pci? dev ? function ? # Atheros 5210/5211/5212 802.11 242#ipw* at pci? dev ? function ? # Intel PRO/Wireless 2100 243#iwi* at pci? dev ? function ? # Intel PRO/Wireless 2200BG 244sip* at pci? dev ? function ? # SiS 900/DP83815 Ethernet 245wi* at pci? dev ? function ? # Intersil Prism Mini-PCI (802.11b) 246 247# PCI crypto coprocessors 248hifn* at pci? dev ? function ? # Hifn 7755/7811/795x 249 250# PCMCIA network interfaces 251awi* at pcmcia? function ? 252wi* at pcmcia? function ? # Lucent/Intersil WaveLAN/IEEE (802.11) 253 254# MII/PHY support 255nsphyter* at mii? phy ? # NS83843 PHYs 256 257# Pseudo-Devices 258 259pseudo-device crypto # opencrypto framework 260 261# network pseudo-devices 262pseudo-device bpfilter # Berkeley packet filter 263pseudo-device ipfilter # IP filter (firewall) and NAT 264pseudo-device loop # network loopback 265pseudo-device ppp # Point-to-Point Protocol 266pseudo-device pppoe # PPP over Ethernet (RFC 2516) 267#pseudo-device sl # Serial Line IP 268#pseudo-device strip # Starmode Radio IP (Metricom) 269pseudo-device tun # network tunneling over tty 270pseudo-device tap # virtual Ethernet 271pseudo-device gre # generic L3 over IP tunnel 272pseudo-device gif # IPv[46] over IPv[46] tunnel (RFC 1933) 273pseudo-device faith # IPv[46] TCP relay translation i/f 274pseudo-device stf # 6to4 IPv6 over IPv4 encapsulation 275pseudo-device vlan # IEEE 802.1q encapsulation 276pseudo-device bridge # simple inter-network bridging 277 278# miscellaneous pseudo-devices 279pseudo-device pty # pseudo-terminals 280#pseudo-device sequencer # MIDI sequencer 281# rnd works; RND_COM does not on port i386 yet. 282#options RND_COM # use "com" randomness as well (BROKEN) 283pseudo-device clockctl # user control of clock subsystem 284#pseudo-device fss # file system snapshot device 285