MMTAICE revision 1.54
1#	$NetBSD: MMTAICE,v 1.54 2017/07/29 18:08:58 maxv Exp $
2#
3#	GENERIC -- everything that's currently supported
4#
5
6include "arch/mmeye/conf/std.mmeye"
7
8#options 	INCLUDE_CONFIG_FILE	# embed config file in kernel binary
9
10# Enable the hooks used for initializing the root memory-disk.
11#options 	MEMORY_DISK_HOOKS
12#options 	MEMORY_DISK_IS_ROOT	# force root on memory disk
13#options 	MEMORY_DISK_SERVER=0	# no userspace memory disk support
14#options 	MEMORY_DISK_ROOT_SIZE=3074	# size of memory disk, in blocks
15
16maxusers	32		# estimated number of users
17
18# CPU support.  At least one is REQUIRED.
19options		SH3
20options 	SH7708		# 60MHz
21#options 	SH7708R		# 100MHz
22options 	PCLOCK=33330000		# 33.33MHz
23options 	INITTODR_ALWAYS_USE_RTC
24
25options 	IOM_RAM_SIZE=0x01000000	# 16MB
26options 	IOM_RAM_BEGIN=0x0c000000
27makeoptions	DEFTEXTADDR="0x8c010000"
28
29# CPU-related options.
30#options 	MATH_EMULATE	# floating point emulation
31# eliminate delay no-ops in I/O; recommended on all but very old machines
32#options 	DUMMY_NOPS
33
34# Misc. i386-specific options
35#options 	XSERVER		# X server support in console drivers
36
37# This option allows you to force a serial console at the specified
38# I/O address.   see console(4) for details.
39#options 	CONSDEVNAME="\"com\""
40
41# The following options override the memory sizes passed in from the boot
42# block.  Use them *only* if the boot block is unable to determine the correct
43# values.  Note that the BIOS may *correctly* report less than 640k of base
44# memory if the extended BIOS data area is located at the top of base memory
45# (as is the case on most recent systems).
46#options 	REALBASEMEM=...	# size of base memory
47#options 	REALEXTMEM=...	# size of extended memory
48
49# Standard system options
50
51options 	INSECURE	# disable kernel security levels
52
53options 	RTC_OFFSET=0	# hardware clock is this many mins. west of GMT
54options 	HZ=10		# clock interrupt generates every 1/10 sec
55				# for Debug
56#options 	NTP		# NTP phase/frequency locked loop
57
58#options 	KTRACE		# system call tracing via ktrace(1)
59
60options 	SYSVMSG		# System V-like message queues
61options 	SYSVSEM		# System V-like semaphores
62options 	SYSVSHM		# System V-like memory sharing
63
64options 	USERCONF	# userconf(4) support
65#options	PIPE_SOCKETPAIR	# smaller, but slower pipe(2)
66#options 	SYSCTL_INCLUDE_DESCR	# Include sysctl descriptions in kernel
67
68# Diagnostic/debugging support options
69#options 	DIAGNOSTIC	# cheap kernel consistency checks
70#options 	DEBUG		# expensive debugging checks/support
71#options 	DDB		# in-kernel debugger
72#options 	KGDB		# remote debugger
73#options 	KGDB_DEVNAME="\"com\"",KGDB_DEVADDR=0x3f8,KGDB_DEVRATE=9600
74#makeoptions	DEBUG="-g"	# compile full symbol table
75options 	SYSCALL_DEBUG
76
77# Compatibility options
78options 	COMPAT_43	# and 4.3BSD
79options 	BSDDISKLABEL_EI	# endian independent disklabel support
80options 	COMPAT_MMEYE_OLDLABEL	# old mmeye's disklabel support
81options		COMPAT_BSDPTY	# /dev/[pt]ty?? ptys.
82
83# Executable format options
84options 	EXEC_COFF	# 32-bit COFF executables (sh-compiler)
85
86# File systems
87file-system 	FFS		# UFS
88#file-system 	EXT2FS		# second extended file system (linux)
89#file-system 	LFS		# log-structured file system
90file-system 	MFS		# memory file system
91file-system 	NFS		# Network File System client
92#file-system 	CD9660		# ISO 9660 + Rock Ridge file system
93#file-system 	MSDOSFS		# MS-DOS file system
94file-system 	FDESC		# /dev/fd
95file-system 	KERNFS		# /kern
96file-system 	NULLFS		# loopback file system
97file-system 	PROCFS		# /proc
98file-system 	UMAPFS		# NULLFS + uid and gid remapping
99#file-system 	UNION		# union file system
100file-system	PTYFS		# /dev/pts/N support
101
102# File system options
103#options 	QUOTA		# legacy UFS quotas
104#options 	QUOTA2		# new, in-filesystem UFS quotas
105options 	NFSSERVER	# Network File System server
106#options 	FIFO		# FIFOs; RECOMMENDED
107options 	FFS_NO_SNAPSHOT	# No FFS snapshot support
108#options 	EXT2FS_SYSTEM_FLAGS # makes ext2fs file flags (append and
109				# immutable) behave as system flags.
110
111# Networking options
112#options 	GATEWAY		# packet forwarding
113options 	INET		# IP + ICMP + TCP + UDP
114#options 	MROUTING	# IP multicast routing
115#options 	PIM		# Protocol Independent Multicast
116#options 	NETATALK	# AppleTalk networking protocols
117#options 	PPP_BSDCOMP	# BSD-Compress compression support for PPP
118#options 	PPP_DEFLATE	# Deflate compression support for PPP
119#options 	PPP_FILTER	# Active filter support for PPP (requires bpf)
120#options 	TCP_DEBUG	# Record last TCP_NDEBUG packets with SO_DEBUG
121
122# These options enable verbose messages for several subsystems.
123# Warning, these may compile large string tables into the kernel!
124options 	PCMCIAVERBOSE	# verbose PCMCIA configuration messages
125#options 	SCSIVERBOSE	# human readable SCSI error messages
126
127# Kernel root file system and dump configuration.
128#config		netbsd	root on ? type ?
129#config		netbsd	root on sd0a type ffs
130#config		netbsd	root on ? type nfs
131config		netbsd	root on wd0a type ffs
132
133#
134# Device configuration
135#
136
137mainbus0 at root
138
139shb* at mainbus?
140
141rtc*	at shb?
142
143com0	at mainbus? addr1 0xa4000000 irq1 11
144com1	at mainbus? addr1 0xa4000008 irq1 12
145
146# SH PCMCIA controllers
147mmeyepcmcia0 at mainbus? addr1 0xb000000a addr2 0xb8000000 irq1 3 irq2 10
148mmeyepcmcia1 at mainbus? addr1 0xb000000c addr2 0xb9000000 irq1 4 irq2 9
149
150# PCMCIA bus support
151pcmcia*	at mmeyepcmcia? controller ? socket ?
152
153# PCMCIA serial interfaces
154com*	at pcmcia? function ?		# Modems and serial cards
155
156
157# SCSI Controllers and Devices
158
159# PCMCIA SCSI controllers
160#aic*	at pcmcia? function ?		# Adaptec APA-1460 SCSI
161
162# SCSI bus support
163#scsibus* at aic?
164
165# SCSI devices
166#sd*	at scsibus? target ? lun ?	# SCSI disk drives
167#st*	at scsibus? target ? lun ?	# SCSI tape drives
168#cd*	at scsibus? target ? lun ?	# SCSI CD-ROM drives
169#ch*	at scsibus? target ? lun ?	# SCSI autochangers
170#ss*	at scsibus? target ? lun ?	# SCSI scanners
171#uk*	at scsibus? target ? lun ?	# SCSI unknown
172
173
174# IDE and Related Devices
175
176wdc* at pcmcia? function ?
177
178# ATA (IDE) bus support
179atabus* at ata?
180
181# IDE drives
182wd*	at atabus? drive ?
183
184# ATAPI bus support
185#atapibus* at atapi?
186
187# ATAPI devices
188#cd*	at atapibus? drive ?		# ATAPI CD-ROM drives
189
190
191# Miscellaneous mass storage devices
192
193
194# Network Interfaces
195
196# PCMCIA network interfaces
197ep*	at pcmcia? function ?		# 3Com 3c589 and 3c562 Ethernet
198ne*	at pcmcia? function ?		# NE2000-compatible Ethernet
199#sm*	at pcmcia? function ?		# Megahertz Ethernet
200
201# MII/PHY support
202exphy*	at mii? phy ?			# 3Com internal PHYs
203icsphy*	at mii? phy ?			# Integrated Circuit Systems ICS189x
204inphy*	at mii? phy ?			# Intel 82555 PHYs
205lxtphy*	at mii? phy ?			# Level One LXT-970 PHYs
206nsphy*	at mii? phy ?			# NS83840 PHYs
207qsphy*	at mii? phy ?			# Quality Semiconductor QS6612 PHYs
208sqphy*	at mii? phy ?			# Seeq 80220/80221/80223 PHYs
209#tlphy*	at mii? phy ?			# ThunderLAN PHYs
210ukphy*	at mii? phy ?			# generic unknown PHYs
211
212
213# Pull in optional local configuration
214cinclude "arch/mmeye/conf/GENERIC.local"
215
216
217# Pseudo-Devices
218
219# disk/mass storage pseudo-devices
220pseudo-device	ccd			# concatenated/striped disk devices
221#pseudo-device	fss			# file system snapshot device
222pseudo-device	md			# memory disk device (ramdisk)
223pseudo-device	vnd			# disk-like interface to files
224
225# network pseudo-devices
226#pseudo-device	bpfilter		# Berkeley packet filter
227#pseudo-device	ipfilter		# IP filter (firewall) and NAT
228pseudo-device	loop			# network loopback
229pseudo-device	ppp			# Point-to-Point Protocol
230#pseudo-device	sl			# Serial Line IP
231#pseudo-device	strip			# Starmode Radio IP (Metricom)
232pseudo-device	tun			# network tunneling over tty
233
234# miscellaneous pseudo-devices
235pseudo-device	pty			# pseudo-terminals
236pseudo-device	clockctl		# user control of clock subsystem
237
238# rnd is EXPERIMENTAL at this point.
239#options 	RND_COM			# use "com" randomness as well (BROKEN)
240