xref: /src/sys/arch/sun3/conf/FOUR_TTYS

#	$NetBSD: FOUR_TTYS,v 1.31.4.1 2002/08/01 04:34:01 lukem Exp $

# FOUR_TTYS Sun3 (3/50, 3/60, 3/110, 3/160, 3/260)
# like GENERIC but both zs chips are used as ttys

include "arch/sun3/conf/std.sun3"

#options 	INCLUDE_CONFIG_FILE	# embed config file in kernel binary

# Machines to be supported by this kernel
options 	FPU_EMULATE
options 	HAVECACHE		# Sun3/260 VAC

# Needs to be set per system.  i.e change these as you see fit
maxusers	4

# Standard system options
options 	KTRACE		# system call tracing
options 	SYSVMSG		# System V message queues
options 	SYSVSEM		# System V semaphores
options 	SYSVSHM		# System V shared memory
#options 	SHMMAXPGS=1024	# 1024 pages is the default
options 	LKM		# loadable kernel modules
#options 	INSECURE	# disable kernel security level
#options 	UCONSOLE	# Allow non-root TIOCCONS
#options 	USERCONF	# userconf(4) support
#options	PIPE_SOCKETPAIR	# smaller, but slower pipe(2)

# Which kernel debugger?  Uncomment either this:
options 	DDB
# ... or these for KGDB (gdb remote target)
#makeoptions	DEBUG="-g"	# debugging symbols for gdb
#options 	KGDB
#options 	KGDB_DEV=0x0C01	# ttya=0C00 ttyb=0C01

# Other debugging options
#options 	DDB_HISTORY_SIZE=100	# enable history editing in DDB
#options 	DEBUG		# kernel debugging code
#options 	DIAGNOSTIC	# extra kernel sanity checking
#options 	KMEMSTATS	# kernel memory statistics (vmstat -m)
#options 	PMAP_DEBUG
#options 	SCSIDEBUG
#options 	SCSIVERBOSE		# Verbose SCSI errors

# Compatibility options
options 	COMPAT_SUNOS	# can run SunOS 4.1.1 executables
options 	COMPAT_43	# and 4.3BSD and ...
options 	COMPAT_10	# NetBSD 1.0
options 	COMPAT_11	# NetBSD 1.1
options 	COMPAT_12	# NetBSD 1.2
options 	COMPAT_13	# NetBSD 1.3
options 	COMPAT_14	# NetBSD 1.4
options 	COMPAT_AOUT_M68K # support for NetBSD a.out executables
#options 	COMPAT_LINUX	# can run Linux/m68k executables
options 	EXEC_AOUT	# support for a.out executables
#options 	TCP_DEBUG	# Record last TCP_NDEBUG packets with SO_DEBUG

# Filesystem options
file-system	FFS		# Berkeley Fast Filesystem
file-system	NFS		# Sun NFS client support
file-system	CD9660		# ISO 9660 + Rock Ridge file system
file-system	FDESC		# /dev/fd/*
file-system	KERNFS		# /kern
file-system	NULLFS		# loopback file system
file-system	PROCFS		# /proc
file-system	UNION		# union file system
file-system	MFS		# memory-based filesystem

options 	NFSSERVER	# nfs server support
options 	QUOTA		# FFS quotas
#options 	FFS_EI		# FFS Endian Independant support

# Networking options
options 	INET		# IP prototol stack support
#options 	GATEWAY		# IP packet forwarding
#options 	ISO,TPIP	# OSI networking
#options 	EON		# OSI tunneling over IP
#options 	CCITT,LLC,HDLC	# X.25
#options 	PFIL_HOOKS	# pfil(9) packet filter hooks.
#options 	TCP_COMPAT_42	# 4.2BSD TCP/IP bug compat. Not recommended.

# Work-around for root on slow servers (insurance...)
options 	NFS_BOOT_RWSIZE=1024
options 	NFS_BOOT_BOOTPARAM

config		netbsd root on ? type ?

# On-board I/O space (required)
include "arch/sun3/conf/obio.sun3"

# On-board memory (optional)
# See frame-buffers
obmem0 at mainbus?

# VME bus support (optional)
# One unit for each address space
vme0 at mainbus? # A16/D16
vme1 at mainbus? # A16/D32
vme2 at mainbus? # A24/D16
vme3 at mainbus? # A24/D32
vme4 at mainbus? # A32/D16
vme5 at mainbus? # A32/D32

#
# Serial ports
#
zstty0	at zsc1 channel 0	# ttya
zstty1	at zsc1 channel 1	# ttyb
#
# Note that by ommitting "kdb0" and "ms0" one can build
# a kernel that operates four plain serial lines, where
# two of them are data-leads-only ports wired up using
# a custom cable on the keyboard connector.  The flags 1
# part sets TIOCFLAG_SOFTCAR (remember, data-leads-only).
# Note: the signal levels on these are 0/5 Volt TTL.
#
zstty2	at zsc0 channel 0 flags 1 # ttyc
zstty3	at zsc0 channel 1 flags 1 # ttyd

#
# Network devices
#

# Intel Ethernet (onboard, or VME)
ie0 at obio0 addr 0x0C0000 ipl 3
ie1 at vme2 addr 0xe88000 ipl 3 vect 0x75

# Lance Ethernet (only onboard)
le0 at obio0 addr 0x120000 ipl 3

# All Sun3 machines with an "le" (3/50, 3/60) should be
# presumed to have the old, buggy LANCE chip. (Rev. C)
options 	LANCE_REVC_BUG

#
# Disk and tape devices
#

# Sun3 "si" SCSI controller (NCR 5380)
# See GENERIC for the flags description.
si0 at obio0 addr 0x140000 ipl 2
si0 at vme2 addr 0x200000 ipl 2 vect 0x40
si1 at vme2 addr 0x204000 ipl 2 vect 0x41

# Xylogics 450/451 controllers (VME A16/D16)
xyc0 at vme0 addr 0xee40 ipl 2 vect 0x48
xyc1 at vme0 addr 0xee48 ipl 2 vect 0x49
xy* at xyc? drive ?

# Xylogics 7053 controllers (VME A16/D32)
xdc0 at vme1 addr 0xee80 ipl 2 vect 0x44
xdc1 at vme1 addr 0xee90 ipl 2 vect 0x45
xd* at xdc? drive ?

# Xylogics 472 tape controllers?

# Sun3/E SCSI+Ethernet board (VME A24/D16)
# Note: the board uses vect and vect+1
sebuf0 at vme2 addr 0x300000 ipl 2 vect 0x74 # and 0x75
sebuf1 at vme2 addr 0x340000 ipl 2 vect 0x76 # and 0x77
si* at sebuf?
ie* at sebuf?

#
# Frame buffer devices
# (not useful if no kbd, right?)

#
# SCSI infrastructure
#
scsibus* at scsi?

sd* at scsibus? target ? lun ?		# SCSI disks
st* at scsibus? target ? lun ?		# SCSI tapes
cd* at scsibus? target ? lun ?		# SCSI CD-ROMs
ch* at scsibus? target ? lun ?		# SCSI changer devices
ss* at scsibus? target ? lun ?		# SCSI scanners
uk* at scsibus? target ? lun ?		# unknown SCSI devices

# Memory-disk drivers
pseudo-device	md		2

# Misc.
pseudo-device	loop		1	# network loopback
pseudo-device	bpfilter	8	# packet filter
pseudo-device	sl		2	# CSLIP
pseudo-device	ppp		2	# PPP
pseudo-device	tun		2	# network tunneling over tty
#pseudo-device	gre		2	# generic L3 over IP tunnel
#pseudo-device	ipfilter		# ip filter
#pseudo-device	rnd			# /dev/random and in-kernel generator

pseudo-device	pty			# pseudo-terminals
#pseudo-device	vnd		4	# paging to files
#pseudo-device	ccd		4	# concatenated disks
#pseudo-device	raid		4	# RAIDframe disk driver
pseudo-device	clockctl		# user control of clock subsystem