sereg.h revision 1.5 1 1.5 wiz /* $NetBSD: sereg.h,v 1.5 2003/05/03 18:11:04 wiz Exp $ */
2 1.1 gwr
3 1.1 gwr /*-
4 1.1 gwr * Copyright (c) 1997 The NetBSD Foundation, Inc.
5 1.1 gwr * All rights reserved.
6 1.1 gwr *
7 1.1 gwr * This code is derived from software contributed to The NetBSD Foundation
8 1.1 gwr * by Gordon W. Ross.
9 1.1 gwr *
10 1.1 gwr * Redistribution and use in source and binary forms, with or without
11 1.1 gwr * modification, are permitted provided that the following conditions
12 1.1 gwr * are met:
13 1.1 gwr * 1. Redistributions of source code must retain the above copyright
14 1.1 gwr * notice, this list of conditions and the following disclaimer.
15 1.1 gwr * 2. Redistributions in binary form must reproduce the above copyright
16 1.1 gwr * notice, this list of conditions and the following disclaimer in the
17 1.1 gwr * documentation and/or other materials provided with the distribution.
18 1.1 gwr * 3. All advertising materials mentioning features or use of this software
19 1.1 gwr * must display the following acknowledgement:
20 1.1 gwr * This product includes software developed by the NetBSD
21 1.1 gwr * Foundation, Inc. and its contributors.
22 1.1 gwr * 4. Neither the name of The NetBSD Foundation nor the names of its
23 1.1 gwr * contributors may be used to endorse or promote products derived
24 1.1 gwr * from this software without specific prior written permission.
25 1.1 gwr *
26 1.1 gwr * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
27 1.1 gwr * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
28 1.1 gwr * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
29 1.1 gwr * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
30 1.1 gwr * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
31 1.1 gwr * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
32 1.1 gwr * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
33 1.1 gwr * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
34 1.1 gwr * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
35 1.1 gwr * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
36 1.1 gwr * POSSIBILITY OF SUCH DAMAGE.
37 1.1 gwr */
38 1.1 gwr
39 1.1 gwr /*
40 1.1 gwr * Sun3/E SCSI/Ethernet board. This is a VME board with some memory,
41 1.1 gwr * an Intel Ether, and an NCR5380 SCSI with a cheap DMA engine.
42 1.1 gwr */
43 1.1 gwr
44 1.1 gwr /*****************************************************************
45 1.1 gwr * Register definitions for the SCSI portion.
46 1.2 gwr * (size=0x20)
47 1.1 gwr */
48 1.1 gwr struct se_regs {
49 1.1 gwr u_char ncrregs[8];
50 1.1 gwr u_short unused1;
51 1.1 gwr u_short dma_addr; /* DMA offset register */
52 1.1 gwr u_short unused2;
53 1.1 gwr u_short dma_cntr; /* DMA count down register */
54 1.2 gwr u_short unused3[5];
55 1.1 gwr u_short se_csr; /* control/status register */
56 1.3 gwr u_short unused4;
57 1.3 gwr u_short se_ivec; /* interrupt vector */
58 1.1 gwr };
59 1.1 gwr
60 1.1 gwr /*
61 1.1 gwr * SCSI Control and Status Register.
62 1.1 gwr * Note:
63 1.1 gwr * (ro) indicates bit is read only.
64 1.1 gwr * (rw) indicates bit is read or write.
65 1.1 gwr */
66 1.1 gwr #define SE_CSR_SBC_IP 0x0200 /* (ro) sbc interrupt pending */
67 1.5 wiz #define SE_CSR_SEND 0x0008 /* (rw) DMA dir, 1=to device */
68 1.1 gwr #define SE_CSR_INTR_EN 0x0004 /* (rw) interrupts enable */
69 1.1 gwr #define SE_CSR_VCC 0x0002 /* (ro) power signal to the chip */
70 1.1 gwr #define SE_CSR_SCSI_RES 0x0001 /* (rw) reset sbc and udc, 0=reset */
71 1.1 gwr
72 1.1 gwr
73 1.1 gwr /*****************************************************************
74 1.4 gwr * Register definitions for the Ethernet portion.
75 1.2 gwr * (size=0x100)
76 1.1 gwr */
77 1.1 gwr struct ie_regs {
78 1.1 gwr u_short ie_pad0;
79 1.1 gwr u_short ie_csr;
80 1.3 gwr u_short ie_pad1[7];
81 1.3 gwr u_short ie_ivec; /* interrupt vector */
82 1.1 gwr u_short ie_pad3[128-10];
83 1.1 gwr };
84 1.1 gwr
85 1.1 gwr /*
86 1.1 gwr * Ether Control and Status Register.
87 1.1 gwr */
88 1.1 gwr #define IE_CSR_RESET 0x8000 /* board reset */
89 1.1 gwr #define IE_CSR_NOLOOP 0x4000 /* loopback disable */
90 1.1 gwr #define IE_CSR_ATTEN 0x2000 /* channel attention */
91 1.1 gwr #define IE_CSR_IENAB 0x1000 /* interrupt enable */
92 1.1 gwr #define IE_CSR_IPEND 0x0100 /* interrupt pending */
93 1.1 gwr
94 1.1 gwr
95 1.1 gwr /*****************************************************************
96 1.1 gwr * Register definitions for the entire SCSI/Ethernet board.
97 1.2 gwr * I had the impression that there were overlaps in this map,
98 1.2 gwr * which was the reason for existence of the "sebuf" driver.
99 1.2 gwr * Now it looks like the "sebuf" driver was unnecessary. XXX
100 1.1 gwr */
101 1.1 gwr
102 1.2 gwr #define SE_NCRBUFSIZE 0x10000
103 1.2 gwr #define SE_IEBUFSIZE 0x20000
104 1.1 gwr struct sebuf_regs {
105 1.1 gwr char se_scsi_buf[SE_NCRBUFSIZE];
106 1.1 gwr struct se_regs se_scsi_regs;
107 1.2 gwr char se_pad[0x10000 - 0x120];
108 1.2 gwr struct ie_regs se_eth_regs;
109 1.1 gwr char se_eth_buf[SE_IEBUFSIZE];
110 1.1 gwr }; /* 128KB total */
111