i2c_bitbang.c revision 1.7 1 /* $NetBSD: i2c_bitbang.c,v 1.7 2007/04/30 00:07:54 macallan Exp $ */
2
3 /*
4 * Copyright (c) 2003 Wasabi Systems, Inc.
5 * All rights reserved.
6 *
7 * Written by Jason R. Thorpe for Wasabi Systems, Inc.
8 *
9 * Redistribution and use in source and binary forms, with or without
10 * modification, are permitted provided that the following conditions
11 * are met:
12 * 1. Redistributions of source code must retain the above copyright
13 * notice, this list of conditions and the following disclaimer.
14 * 2. Redistributions in binary form must reproduce the above copyright
15 * notice, this list of conditions and the following disclaimer in the
16 * documentation and/or other materials provided with the distribution.
17 * 3. All advertising materials mentioning features or use of this software
18 * must display the following acknowledgement:
19 * This product includes software developed for the NetBSD Project by
20 * Wasabi Systems, Inc.
21 * 4. The name of Wasabi Systems, Inc. may not be used to endorse
22 * or promote products derived from this software without specific prior
23 * written permission.
24 *
25 * THIS SOFTWARE IS PROVIDED BY WASABI SYSTEMS, INC. ``AS IS'' AND
26 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
27 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
28 * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL WASABI SYSTEMS, INC
29 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
30 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
31 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
32 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
33 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
34 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
35 * POSSIBILITY OF SUCH DAMAGE.
36 */
37
38 /*
39 * Common module for bit-bang'ing an I2C bus.
40 */
41
42 #include <sys/param.h>
43
44 #include <dev/i2c/i2cvar.h>
45 #include <dev/i2c/i2c_bitbang.h>
46
47 #define SETBITS(x) ops->ibo_set_bits(v, (x))
48 #define DIR(x) ops->ibo_set_dir(v, (x))
49 #define READ ops->ibo_read_bits(v)
50
51 #define SDA ops->ibo_bits[I2C_BIT_SDA] /* i2c signal */
52 #define SCL ops->ibo_bits[I2C_BIT_SCL] /* i2c signal */
53 #define OUTPUT ops->ibo_bits[I2C_BIT_OUTPUT] /* SDA is output */
54 #define INPUT ops->ibo_bits[I2C_BIT_INPUT] /* SDA is input */
55
56 #ifndef SCL_BAIL_COUNT
57 #define SCL_BAIL_COUNT 1000
58 #endif
59
60 static inline int i2c_wait_for_scl(void *, i2c_bitbang_ops_t);
61
62 static inline int
63 i2c_wait_for_scl(void *v, i2c_bitbang_ops_t ops)
64 {
65 int bail = 0;
66
67 while (((READ & SCL) == 0) && (bail < SCL_BAIL_COUNT)) {
68
69 delay(1);
70 bail++;
71 }
72 if (bail == SCL_BAIL_COUNT) {
73
74 i2c_bitbang_send_stop(v, 0, ops);
75 return EIO;
76 }
77 return 0;
78 }
79
80 /*ARGSUSED*/
81 int
82 i2c_bitbang_send_start(void *v, int flags, i2c_bitbang_ops_t ops)
83 {
84
85 DIR(OUTPUT);
86
87 SETBITS(SDA | SCL);
88 delay(5); /* bus free time (4.7 uS) */
89 SETBITS( SCL);
90 if (i2c_wait_for_scl(v, ops) != 0)
91 return EIO;
92 delay(4); /* start hold time (4.0 uS) */
93 SETBITS( 0);
94 delay(5); /* clock low time (4.7 uS) */
95
96 return (0);
97 }
98
99 /*ARGSUSED*/
100 int
101 i2c_bitbang_send_stop(void *v, int flags, i2c_bitbang_ops_t ops)
102 {
103
104 DIR(OUTPUT);
105
106 SETBITS( SCL);
107 delay(4); /* stop setup time (4.0 uS) */
108 SETBITS(SDA | SCL);
109
110 return (0);
111 }
112
113 int
114 i2c_bitbang_initiate_xfer(void *v, i2c_addr_t addr, int flags,
115 i2c_bitbang_ops_t ops)
116 {
117
118 if (addr < 0x80) {
119 uint8_t i2caddr;
120
121 /* disallow the 10-bit address prefix */
122 if ((addr & 0x78) == 0x78)
123 return EINVAL;
124 i2caddr = (addr << 1) | ((flags & I2C_F_READ) ? 1 : 0);
125 (void) i2c_bitbang_send_start(v, flags, ops);
126
127 return (i2c_bitbang_write_byte(v, i2caddr,
128 flags & ~I2C_F_STOP, ops));
129
130 } else if (addr < 0x400) {
131 uint16_t i2caddr;
132 int rv;
133
134 i2caddr = (addr << 1) | ((flags & I2C_F_READ) ? 1 : 0) |
135 0xf000;
136
137 (void) i2c_bitbang_send_start(v, flags, ops);
138 rv = i2c_bitbang_write_byte(v, i2caddr >> 8,
139 flags & ~I2C_F_STOP, ops);
140 /* did a slave ack the 10-bit prefix? */
141 if (rv != 0)
142 return rv;
143
144 /* send the lower 7-bits (+ read/write mode) */
145 return (i2c_bitbang_write_byte(v, i2caddr & 0xff,
146 flags & ~I2C_F_STOP, ops));
147
148 } else
149 return EINVAL;
150 }
151
152 int
153 i2c_bitbang_read_byte(void *v, uint8_t *valp, int flags,
154 i2c_bitbang_ops_t ops)
155 {
156 int i;
157 uint8_t val = 0;
158 uint32_t bit;
159
160 DIR(INPUT);
161 SETBITS(SDA );
162
163 for (i = 0; i < 8; i++) {
164 val <<= 1;
165 SETBITS(SDA | SCL);
166 if (i2c_wait_for_scl(v, ops) != 0)
167 return EIO;
168 delay(4); /* clock high time (4.0 uS) */
169 if (READ & SDA)
170 val |= 1;
171 SETBITS(SDA );
172 delay(5); /* clock low time (4.7 uS) */
173 }
174
175 bit = (flags & I2C_F_LAST) ? SDA : 0;
176 DIR(OUTPUT);
177 SETBITS(bit );
178 delay(1); /* data setup time (250 nS) */
179 SETBITS(bit | SCL);
180 if (i2c_wait_for_scl(v, ops) != 0)
181 return EIO;
182 delay(4); /* clock high time (4.0 uS) */
183 SETBITS(bit );
184 delay(5); /* clock low time (4.7 uS) */
185
186 DIR(INPUT);
187 SETBITS(SDA );
188 delay(5);
189
190 if ((flags & (I2C_F_STOP | I2C_F_LAST)) == (I2C_F_STOP | I2C_F_LAST))
191 (void) i2c_bitbang_send_stop(v, flags, ops);
192
193 *valp = val;
194 return (0);
195 }
196
197 int
198 i2c_bitbang_write_byte(void *v, uint8_t val, int flags,
199 i2c_bitbang_ops_t ops)
200 {
201 uint32_t bit;
202 uint8_t mask;
203 int error;
204
205 DIR(OUTPUT);
206
207 for (mask = 0x80; mask != 0; mask >>= 1) {
208 bit = (val & mask) ? SDA : 0;
209 SETBITS(bit );
210 delay(1); /* data setup time (250 nS) */
211 SETBITS(bit | SCL);
212 if (i2c_wait_for_scl(v, ops))
213 return EIO;
214 delay(4); /* clock high time (4.0 uS) */
215 SETBITS(bit );
216 delay(5); /* clock low time (4.7 uS) */
217 }
218
219 DIR(INPUT);
220
221 SETBITS(SDA );
222 delay(5);
223 SETBITS(SDA | SCL);
224 if (i2c_wait_for_scl(v, ops) != 0)
225 return EIO;
226 delay(4);
227 error = (READ & SDA) ? EIO : 0;
228 SETBITS(SDA );
229 delay(5);
230
231 if (flags & I2C_F_STOP)
232 (void) i2c_bitbang_send_stop(v, flags, ops);
233
234 return (error);
235 }
236