rf3000reg.h revision 1.3.2.2
1 1.3.2.2 skrll /* $NetBSD: rf3000reg.h,v 1.3.2.2 2004/08/03 10:46:18 skrll Exp $ */ 2 1.3.2.2 skrll 3 1.3.2.2 skrll /* 4 1.3.2.2 skrll * Copyright (c) 2005 David Young. All rights reserved. 5 1.3.2.2 skrll * 6 1.3.2.2 skrll * This code was written by David Young. 7 1.3.2.2 skrll * 8 1.3.2.2 skrll * Redistribution and use in source and binary forms, with or without 9 1.3.2.2 skrll * modification, are permitted provided that the following conditions 10 1.3.2.2 skrll * are met: 11 1.3.2.2 skrll * 1. Redistributions of source code must retain the above copyright 12 1.3.2.2 skrll * notice, this list of conditions and the following disclaimer. 13 1.3.2.2 skrll * 2. Redistributions in binary form must reproduce the above copyright 14 1.3.2.2 skrll * notice, this list of conditions and the following disclaimer in the 15 1.3.2.2 skrll * documentation and/or other materials provided with the distribution. 16 1.3.2.2 skrll * 3. Neither the name of the author nor the names of any co-contributors 17 1.3.2.2 skrll * may be used to endorse or promote products derived from this software 18 1.3.2.2 skrll * without specific prior written permission. 19 1.3.2.2 skrll * 20 1.3.2.2 skrll * THIS SOFTWARE IS PROVIDED BY David Young ``AS IS'' AND ANY 21 1.3.2.2 skrll * EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, 22 1.3.2.2 skrll * THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A 23 1.3.2.2 skrll * PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL David 24 1.3.2.2 skrll * Young BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, 25 1.3.2.2 skrll * EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED 26 1.3.2.2 skrll * TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, 27 1.3.2.2 skrll * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND 28 1.3.2.2 skrll * ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, 29 1.3.2.2 skrll * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 30 1.3.2.2 skrll * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY 31 1.3.2.2 skrll * OF SUCH DAMAGE. 32 1.3.2.2 skrll */ 33 1.3.2.2 skrll 34 1.3.2.2 skrll #ifndef _DEV_IC_RF3000REG_H_ 35 1.3.2.2 skrll #define _DEV_IC_RF3000REG_H_ 36 1.3.2.2 skrll 37 1.3.2.2 skrll /* 38 1.3.2.2 skrll * Serial bus format for RF Microdevices RF3000 spread-spectrum 39 1.3.2.2 skrll * baseband modem. 40 1.3.2.2 skrll */ 41 1.3.2.2 skrll #define RF3000_TWI_DATA_MASK 0xff 42 1.3.2.2 skrll #define RF3000_TWI_ADDR_MASK 0x7f 43 1.3.2.2 skrll #define RF3000_TWI_AI 0x80 /* auto-increment */ 44 1.3.2.2 skrll 45 1.3.2.2 skrll /* 46 1.3.2.2 skrll * Registers for RFMD RF3000. 47 1.3.2.2 skrll */ 48 1.3.2.2 skrll #define RF3000_CTL 0x01 /* modem control */ 49 1.3.2.2 skrll #define RF3000_CTL_MODE_MASK BITS(7, 4) 50 1.3.2.2 skrll #define RF3000_CTL_MODE_1MBPS 0 51 1.3.2.2 skrll #define RF3000_CTL_MODE_RSVD0 1 52 1.3.2.2 skrll #define RF3000_CTL_MODE_2MBPS 2 53 1.3.2.2 skrll #define RF3000_CTL_MODE_2MBPS_SHORT 3 54 1.3.2.2 skrll #define RF3000_CTL_MODE_5MBPS 4 55 1.3.2.2 skrll #define RF3000_CTL_MODE_5MBPS_SHORT 5 56 1.3.2.2 skrll #define RF3000_CTL_MODE_11MBPS 6 57 1.3.2.2 skrll #define RF3000_CTL_MODE_11MBPS_SHORT 7 58 1.3.2.2 skrll #define RF3000_CTL_MODE_BPSK 8 59 1.3.2.2 skrll #define RF3000_CTL_MODE_QPSK 9 60 1.3.2.2 skrll #define RF3000_CTL_MODE_RSVD1 10 61 1.3.2.2 skrll #define RF3000_CTL_MODE_RSVD2 11 62 1.3.2.2 skrll #define RF3000_RXSTAT RF3000_CTL /* RX status */ 63 1.3.2.2 skrll #define RF3000_RXSTAT_SHORTPRE BIT(3) /* 1: short preamble */ 64 1.3.2.2 skrll #define RF3000_RXSTAT_ACQ BIT(2) /* 1: acquired */ 65 1.3.2.2 skrll #define RF3000_RXSTAT_SFD BIT(1) /* 1: SFD detected */ 66 1.3.2.2 skrll #define RF3000_RXSTAT_CRC BIT(0) /* 1: CRC invalid */ 67 1.3.2.2 skrll #define RF3000_CCACTL 0x02 /* CCA control */ 68 1.3.2.2 skrll /* CCA mode */ 69 1.3.2.2 skrll #define RF3000_CCACTL_MODE_MASK BITS(7, 6) 70 1.3.2.2 skrll #define RF3000_CCACTL_MODE_RSSIT 0 /* RSSI threshold */ 71 1.3.2.2 skrll #define RF3000_CCACTL_MODE_ACQ 1 /* acquisition */ 72 1.3.2.2 skrll #define RF3000_CCACTL_MODE_BOTH 2 /* threshold or acq. */ 73 1.3.2.2 skrll /* RSSI threshold for CCA */ 74 1.3.2.2 skrll #define RF3000_CCACTL_RSSIT_MASK BITS(5, 0) 75 1.3.2.2 skrll #define RF3000_DIVCTL 0x03 /* diversity control */ 76 1.3.2.2 skrll #define RF3000_DIVCTL_ENABLE BIT(7) /* enable diversity */ 77 1.3.2.2 skrll #define RF3000_DIVCTL_ANTSEL BIT(6) /* if ENABLE = 0, set 78 1.3.2.2 skrll * ANT SEL 79 1.3.2.2 skrll */ 80 1.3.2.2 skrll #define RF3000_RSSI RF3000_DIVCTL /* RSSI value */ 81 1.3.2.2 skrll #define RF3000_RSSI_MASK BITS(5, 0) 82 1.3.2.2 skrll #define RF3000_GAINCTL 0x11 /* TX variable gain control */ 83 1.3.2.2 skrll #define RF3000_GAINCTL_TXVGC_MASK BITS(7, 2) 84 1.3.2.2 skrll #define RF3000_GAINCTL_SCRAMBLER BIT(1) 85 1.3.2.2 skrll #define RF3000_LOGAINCAL 0x14 /* low gain calibration */ 86 1.3.2.2 skrll #define RF3000_LOGAINCAL_CAL_MASK BITS(5, 0) 87 1.3.2.2 skrll #define RF3000_HIGAINCAL 0x15 /* high gain calibration */ 88 1.3.2.2 skrll #define RF3000_HIGAINCAL_CAL_MASK BITS(5, 0) 89 1.3.2.2 skrll #define RF3000_HIGAINCAL_DSSSPAD BIT(6) /* 6dB gain pad for DSSS 90 1.3.2.2 skrll * modes (meaning?) 91 1.3.2.2 skrll */ 92 1.3.2.2 skrll #define RF3000_OPTIONS1 0x1C /* Options Register 1 */ 93 1.3.2.2 skrll /* Saturation threshold is 4 + offset, where -3 <= offset <= 3. 94 1.3.2.2 skrll * SAT_THRESH is the absolute value, SAT_THRESH_SIGN is the sign. 95 1.3.2.2 skrll */ 96 1.3.2.2 skrll #define RF3000_OPTIONS1_SAT_THRESH_SIGN BIT(7) 97 1.3.2.2 skrll #define RF3000_OPTIONS1_SAT_THRESH BITS(6,5) 98 1.3.2.2 skrll #define RF3000_OPTIONS1_ALTAGC BIT(4) /* 1: retrigger AGC 99 1.3.2.2 skrll * algorithm on ADC 100 1.3.2.2 skrll * saturation 101 1.3.2.2 skrll */ 102 1.3.2.2 skrll #define RF3000_OPTIONS1_ALTBUS BIT(3) /* 1: enable alternate 103 1.3.2.2 skrll * Tx/Rx data bus 104 1.3.2.2 skrll * interface. 105 1.3.2.2 skrll */ 106 1.3.2.2 skrll #define RF3000_OPTIONS1_RESERVED0_MASK BITS(2,0)/* 0 */ 107 1.3.2.2 skrll 108 1.3.2.2 skrll #define RF3000_OPTIONS2 0x1D /* Options Register 2 */ 109 1.3.2.2 skrll /* 1: delay next AGC 2us instead of 1us after a 1->0 LNAGS-pin transition. */ 110 1.3.2.2 skrll #define RF3000_OPTIONS2_LNAGS_DELAY BIT(7) 111 1.3.2.2 skrll #define RF3000_OPTIONS2_RESERVED0_MASK BITS(6,3) /* 0 */ 112 1.3.2.2 skrll /* Threshold for AGC re-trigger. 0: high count, 1: low count. */ 113 1.3.2.2 skrll #define RF3000_OPTIONS2_RTG_THRESH BIT(2) 114 1.3.2.2 skrll #define RF3000_OPTIONS2_RESERVED1_MASK BITS(1,0) /* 0 */ 115 1.3.2.2 skrll 116 1.3.2.2 skrll #endif /* _DEV_IC_RF3000REG_H_ */ 117
Indexes created Sat Oct 25 16:10:12 GMT 2025