if_qereg.h revision 1.7
1 /* $NetBSD: if_qereg.h,v 1.7 2003/08/07 16:31:15 agc Exp $ */ 2 /* 3 * Copyright (c) 1988 Regents of the University of California. 4 * All rights reserved. 5 * 6 * This code is derived from software contributed to Berkeley by 7 * Digital Equipment Corp. 8 * 9 * Redistribution and use in source and binary forms, with or without 10 * modification, are permitted provided that the following conditions 11 * are met: 12 * 1. Redistributions of source code must retain the above copyright 13 * notice, this list of conditions and the following disclaimer. 14 * 2. Redistributions in binary form must reproduce the above copyright 15 * notice, this list of conditions and the following disclaimer in the 16 * documentation and/or other materials provided with the distribution. 17 * 3. Neither the name of the University nor the names of its contributors 18 * may be used to endorse or promote products derived from this software 19 * without specific prior written permission. 20 * 21 * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND 22 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 23 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 24 * ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE 25 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 26 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 27 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 28 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 29 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 30 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 31 * SUCH DAMAGE. 32 * 33 * @(#)if_qereg.h 7.3 (Berkeley) 6/28/90 34 */ 35 36 /* @(#)if_qereg.h 1.2 (ULTRIX) 1/3/85 */ 37 38 /**************************************************************** 39 * * 40 * Licensed from Digital Equipment Corporation * 41 * Copyright (c) * 42 * Digital Equipment Corporation * 43 * Maynard, Massachusetts * 44 * 1985, 1986 * 45 * All rights reserved. * 46 * * 47 * The Information in this software is subject to change * 48 * without notice and should not be construed as a commitment * 49 * by Digital Equipment Corporation. Digital makes no * 50 * representations about the suitability of this software for * 51 * any purpose. It is supplied "As Is" without expressed or * 52 * implied warranty. * 53 * * 54 * If the Regents of the University of California or its * 55 * licensees modify the software in a manner creating * 56 * derivative copyright rights, appropriate copyright * 57 * legends may be placed on the derivative work in addition * 58 * to that set forth above. * 59 * * 60 ****************************************************************/ 61 /* --------------------------------------------------------------------- 62 * Modification History 63 * 64 * 13 Feb. 84 -- rjl 65 * 66 * Initial version of driver. derived from IL driver. 67 * 68 * --------------------------------------------------------------------- 69 */ 70 71 /* 72 * Digital Q-BUS to NI Adapter 73 */ 74 #ifdef notdef 75 struct qedevice { 76 u_short qe_sta_addr[2]; /* Station address (actually 6 */ 77 u_short qe_rcvlist_lo; /* Receive list lo address */ 78 u_short qe_rcvlist_hi; /* Receive list hi address */ 79 u_short qe_xmtlist_lo; /* Transmit list lo address */ 80 u_short qe_xmtlist_hi; /* Transmit list hi address */ 81 u_short qe_vector; /* Interrupt vector */ 82 u_short qe_csr; /* Command and Status Register */ 83 }; 84 #endif 85 86 /* 87 * Register offsets in register space. 88 */ 89 #define QE_CSR_ADDR1 0 90 #define QE_CSR_ADDR2 2 91 #define QE_CSR_RCLL 4 92 #define QE_CSR_RCLH 6 93 #define QE_CSR_XMTL 8 94 #define QE_CSR_XMTH 10 95 #define QE_CSR_VECTOR 12 96 #define QE_CSR_CSR 14 97 98 /* 99 * Command and status bits (csr) 100 */ 101 #define QE_RCV_ENABLE 0x0001 /* Receiver enable */ 102 #define QE_RESET 0x0002 /* Software reset */ 103 #define QE_NEX_MEM_INT 0x0004 /* Non existent mem interrupt */ 104 #define QE_LOAD_ROM 0x0008 /* Load boot/diag from rom */ 105 #define QE_XL_INVALID 0x0010 /* Transmit list invalid */ 106 #define QE_RL_INVALID 0x0020 /* Receive list invalid */ 107 #define QE_INT_ENABLE 0x0040 /* Interrupt enable */ 108 #define QE_XMIT_INT 0x0080 /* Transmit interrupt */ 109 #define QE_ILOOP 0x0100 /* Internal loopback */ 110 #define QE_ELOOP 0x0200 /* External loopback */ 111 #define QE_STIM_ENABLE 0x0400 /* Sanity timer enable */ 112 #define QE_POWERUP 0x1000 /* Tranceiver power on */ 113 #define QE_CARRIER 0x2000 /* Carrier detect */ 114 #define QE_RCV_INT 0x8000 /* Receiver interrupt */ 115 116 /* 117 * Transmit and receive ring discriptor --------------------------- 118 * 119 * The QNA uses the flag, status1 and the valid bit as a handshake/semiphore 120 * mechinism. 121 * 122 * The flag word is written on ( bits 15,15 set to 1 ) when it reads the 123 * descriptor. If the valid bit is set it considers the address to be valid. 124 * When it uses the buffer pointed to by the valid address it sets status word 125 * one. 126 */ 127 struct qe_ring { 128 u_short qe_flag; /* Buffer utilization flags */ 129 u_short qe_addr_hi; 130 u_short qe_addr_lo; /* Low order bits of address */ 131 short qe_buf_len; /* Negative buffer length */ 132 u_short qe_status1; /* Status word one */ 133 u_short qe_status2; /* Status word two */ 134 }; 135 136 /* 137 * High word address control bits. 138 */ 139 #define QE_VALID 0x8000 140 #define QE_CHAIN 0x4000 141 #define QE_EOMSG 0x2000 142 #define QE_SETUP 0x1000 143 #define QE_ODDEND 0x0080 144 #define QE_ODDBEGIN 0x0040 145 146 /* 147 * Status word definations (receive) 148 * word1 149 */ 150 #define QE_OVF 0x0001 /* Receiver overflow */ 151 #define QE_CRCERR 0x0002 /* CRC error */ 152 #define QE_FRAME 0x0004 /* Framing alignment error */ 153 #define QE_SHORT 0x0008 /* Packet size < 10 bytes */ 154 #define QE_RBL_HI 0x0700 /* Hi bits of receive len */ 155 #define QE_RUNT 0x0800 /* Runt packet */ 156 #define QE_DISCARD 0x1000 /* Discard the packet */ 157 #define QE_ESETUP 0x2000 /* Looped back setup or eloop */ 158 #define QE_ERROR 0x4000 /* Receiver error */ 159 #define QE_LASTNOT 0x8000 /* Not the last in the packet */ 160 /* word2 */ 161 #define QE_RBL_LO 0x00ff /* Low bits of receive len */ 162 163 /* 164 * Status word definations (transmit) 165 * word1 166 */ 167 #define QE_CCNT 0x00f0 /* Collision count this packet */ 168 #define QE_FAIL 0x0100 /* Heart beat check failure */ 169 #define QE_ABORT 0x0200 /* Transmission abort */ 170 #define QE_STE16 0x0400 /* Sanity timer default on */ 171 #define QE_NOCAR 0x0800 /* No carrier */ 172 #define QE_LOSS 0x1000 /* Loss of carrier while xmit */ 173 /* word2 */ 174 #define QE_TDR 0x3fff /* Time domain reflectometry */ 175 176 /* 177 * General constant definations 178 */ 179 #define QEALLOC 0 /* Allocate an mbuf */ 180 #define QENOALLOC 1 /* No mbuf allocation */ 181 #define QEDEALLOC 2 /* Release an mbuf chain */ 182 183 #define QE_NOTYET 0x8000 /* Descriptor not in use yet */ 184 #define QE_INUSE 0x4000 /* Descriptor being used by QNA */ 185 #define QE_MASK 0xc000 /* Lastnot/error/used mask */ 186 187 /* 188 * Values for the length of the setup packet that control reception filter. 189 */ 190 #define QE_SETUPLEN 128 /* Size of setup packet */ 191 #define QE_ALLMULTI 1 /* Receive all multicasts */ 192 #define QE_PROMISC 2 /* Receive all packets */ 193
Indexes created Tue Sep 30 20:09:53 GMT 2025