| /src/sys/arch/atari/dev/ |
| nvram.c | 102 mc146818_write(RTC, nreg, 0);
128 return mc146818_read(RTC, byteno + MC_NVRAM_START) & 0xff;
167 *p = mc146818_read(RTC, offset + i);
173 mc146818_write(RTC, offset + i, *p);
186 csum += mc146818_read(RTC, nreg);
194 if (((~csum & 0xff) != mc146818_read(RTC, MC_NVRAM_CSUM))
195 || (csum != mc146818_read(RTC, MC_NVRAM_CSUM + 1)))
204 mc146818_write(RTC, MC_NVRAM_CSUM, ~csum);
205 mc146818_write(RTC, MC_NVRAM_CSUM + 1, csum);
|
| clockreg.h | 37 #define RTC ((struct rtc *)AD_RTC)
39 struct rtc { struct
|
| clock.c | 106 * 'sc_flags' state info. Only used by the rtc-device functions.
406 struct rtc *rtc = cookie; local in function:mc146818_read
408 rtc->rtc_regno = regno;
409 return rtc->rtc_data & 0xff;
414 struct rtc *rtc = cookie; local in function:mc146818_write
416 rtc->rtc_regno = regno;
417 rtc->rtc_data = value;
428 regb = mc146818_read(RTC, MC_REGB)
[all...] |
| /src/sys/external/gpl2/dts/dist/arch/arm/boot/dts/ |
| kirkwood-nas2big.dts | 30 rtc@10300 {
31 /* The on-chip RTC is not powered (no supercap). */
92 * An external I2C RTC (Dallas DS1337S+) is used. This allows
93 * to power-up the board on an RTC alarm. The external RTC can
96 rtc@68 {
|
| imx28-eukrea-mbmx287lc.dts | 8 * Module contains : i.MX287 + 128MB DDR2 + NAND + 2 x Ethernet PHY + RTC
|
| imx28-eukrea-mbmx283lc.dts | 8 * Module contains : i.MX282 + 64MB DDR2 + NAND + Ethernet PHY + RTC
35 pcf8563: rtc@51 {
|
| armada-370-seagate-nas-xbay.dtsi | 56 /* RTC - NXP 8563T (second source) */
57 rtc@51 {
62 /* RTC - MCP7940NT */
63 rtc@6f {
|
| armada-370-netgear-rn102.dts | 34 /* RTC is provided by Intersil ISL12057 I2C RTC chip */
35 rtc@10300 {
69 isl12057: rtc@68 {
|
| armada-370-netgear-rn104.dts | 34 /* RTC is provided by Intersil ISL12057 I2C RTC chip */
35 rtc@10300 {
71 isl12057: rtc@68 {
|
| kirkwood-nsa325.dts | 117 /* This board uses the pcf8563 RTC instead of the SoC RTC */
118 rtc@10300 {
|
| am335x-bone-common.dtsi | 280 * Configure pmic to enter OFF-state instead of SLEEP-state ("RTC-only
281 * mode") at poweroff. Most BeagleBone versions do not support RTC-only
292 * if you want to use RTC-only mode and made sure you are not affected
399 &rtc {
|
| armada-370-synology-ds213j.dts | 48 /* RTC provided by Seiko S-35390A I2C RTC chip below */
49 rtc@10300 {
60 /* Main device RTC chip */
|
| am335x-regor.dtsi | 151 /* RTC */
|
| armada-385-linksys.dtsi | 262 &rtc {
263 /* No crystal connected to the internal RTC */
|
| armada-xp-openblocks-ax3-4.dts | 65 rtc@10300 {
66 /* No crystal connected to the internal RTC */
|
| imx6dl-colibri-eval-v3.dts | 130 * Colibri I2C: I2C3_SDA/SCL on SODIMM 194/196 (e.g. RTC on carrier board)
151 rtc_i2c: rtc@68 {
|
| imx6q-apalis-eval.dts | 130 /* I2C1_SDA/SCL on MXM3 209/211 (e.g. RTC on carrier board) */
153 rtc_i2c: rtc@68 {
|
| imx6q-apalis-ixora-v1.1.dts | 135 /* I2C1_SDA/SCL on MXM3 209/211 (e.g. RTC on carrier board) */
153 rtc_i2c: rtc@68 {
|
| imx6q-apalis-ixora.dts | 134 /* I2C1_SDA/SCL on MXM3 209/211 (e.g. RTC on carrier board) */
157 rtc_i2c: rtc@68 {
|
| kirkwood-linksys-viper.dts | 234 /* There is no battery on the board, so the RTC does not keep
237 &rtc {
|
| /src/sys/arch/mac68k/mac68k/ |
| pramasm.s | 4 * RTC toolkit version 1.08b, copyright 1995, erik vogan
45 * The following are the C interface functions to RTC access functions
56 * the MRG method of accessing the ADB/PRAM/RTC.
153 * The following are the C interface functions to RTC access functions
222 * The following are the RTC access functions used by the interface
292 bsr _C_LABEL(Transfer) | and go de-write protect RTC
357 andib #0xF8,%d2 | don't touch any but RTC bits
366 bsr writebyte | write that byte to RTC too
379 bsr readbyte | read a byte from the RTC
382 bsr writebyte | write the data to the RTC
[all...] |
| /src/sys/external/gpl2/dts/dist/arch/mips/boot/dts/ingenic/ |
| rs90.dts | 299 /* Use 32kHz oscillator as the parent of the RTC clock */
306 * 750 kHz for the system timer and clocksource, and use RTC as the
|
| gcw0.dts | 306 /* RTC fixed 3.3V */
450 * Use the 32 kHz oscillator as the parent of the RTC for a higher
482 * and use RTC as the parent for the watchdog clock
505 &rtc {
507 clock-names = "rtc";
|
| /src/sys/external/gpl2/dts/dist/include/dt-bindings/clock/ |
| stm32mp1-clks.h | 205 #define RTC 192
|
| /src/sys/external/bsd/acpica/dist/tools/examples/ |
| extables.c | 446 [0001] RTC Day Alarm Index : 00
447 [0001] RTC Month Alarm Index : 00
448 [0001] RTC Century Index : 00
455 CMOS RTC Not Present (V5) : 0
464 RTC wake not in fixed reg space (V1) : 0
465 RTC can wake system from S4 (V1) : 0
|
