p The RTL8188CE is a highly integrated 802.11n adapter that combines a MAC, a 1T1R capable baseband and an RF in a single chip. It operates in the 2GHz spectrum only.
p The RTL8192CE is a highly integrated multiple-in, multiple-out (MIMO) 802.11n adapter that combines a MAC, a 2T2R capable baseband and an RF in a single chip. It operates in the 2GHz spectrum only.
p These are the modes the .Nm driver can operate in: l -tag -width "IBSS-masterXX" t BSS mode Also known as .Em infrastructure mode, this is used when associating with an access point, through which all traffic passes. This mode is the default. t monitor mode In this mode the driver is able to receive packets without associating with an access point. This disables the internal receive filter and enables the card to capture packets from networks which it wouldn't normally have access to, or to scan for access points. .El
p The .Nm driver can be configured to use Wired Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA-PSK and WPA2-PSK). WPA is the current encryption standard for wireless networks. It is strongly recommended that WEP not be used as the sole mechanism to secure wireless communication, due to serious weaknesses in it.
p The .Nm driver can be configured at runtime with .Xr ifconfig 8 or on boot with .Xr ifconfig.if 5 . .Sh FILES The driver needs the following firmware files, which are loaded when an interface is brought up:
p l -tag -width Ds -offset indent -compact t /libdata/firmware/if_rtwn/rtl8192cfw.bin t /libdata/firmware/if_rtwn/rtl8192cfwU.bin t /libdata/firmware/if_rtwn/rtl8192cfwU_B.bin .El .Sh EXAMPLES The following .Xr ifconfig.if 5 example configures rtwn0 to join whatever network is available on boot, using WEP key .Dq 0x1deadbeef1 , channel 11, obtaining an IP address using DHCP: d -literal -offset indent nwkey 0x1deadbeef1 chan 11 dhcp .Ed
p Join an existing BSS network, .Dq my_net : d -literal -offset indent # ifconfig rtwn0 192.168.1.1 netmask 0xffffff00 nwid my_net .Ed .Sh DIAGNOSTICS l -diag t "rtwn%d: could not read firmware ..." For some reason, the driver was unable to read the microcode file from the filesystem. The file might be missing or corrupted. t "rtwn%d: device timeout" A frame dispatched to the hardware for transmission did not complete in time. The driver will reset the hardware. This should not happen. .El .Sh SEE ALSO .Xr arp 4 , .Xr netintro 4 , .Xr pci 4 , .Xr ifconfig.if 5 , .Xr wpa_supplicant.conf 5 , .Xr ifconfig 8 , .Xr wpa_supplicant 8 .Sh HISTORY The .Nm driver first appeared in .Ox 5.8 and in .Nx 8.0 . .Sh AUTHORS .An -nosplit The .Nm driver was written by .An Stefan Sperling .Aq stsp (at] openbsd.org for .Ox and ported to .Nx by .An NONAKA Kimihiro .Aq nonaka (at] NetBSD.org . It was based on the .Xr urtwn 4 driver written by .An Damien Bergamini .Aq damien.bergamini (at] free.fr . .Sh CAVEATS The .Nm driver does not support any of the 802.11n capabilities offered by the adapters. Additional work is required in .Xr ieee80211 9 before those features can be supported.